User manual MIELE T1520I

[. . . ] Operating Instructions Vented Dryer T 1520 To prevent accidents and machine damage read these instructions before installation or use. U M. -Nr. 05 275 070 Contents IMPORTANT SAFETY INSTRUCTIONS . Turn on the dryer and load the laundry . Select the Buzzer to signal the end of the program (if desired) . [. . . ] ^ Dry the lint filter before putting it back in place. Cleaning the drum and stainless steel parts ^ Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. ^ Wipe dry using a soft cloth. 12 Dryer care Changing the light bulb To reduce the risk of electric shock, disconnect this appliance from the power supply by unplugging or tripping the circuit breaker. , WARNING Power failure - Emergency door release ^ Pull forward on the unhinged side of the door. ^ Unscrew the plastic bulb cover located inside the drum and above the door (see illustration. ) ^ Replace the light bulb with a temperature proof bulb (part # 02 150 900) available from Miele's Technical Service Department. The light bulb must not exceed the maximum wattage quoted on the data plate. Take care that the bulb cover is tightened into place. Otherwise moisture may penetrate the socket and cause a short circuit. 13 Frequently asked questions With the following guide, minor problems can be fixed without a service call. the tumble Check whether the "On" in- Repeat the program selection dryer fails to start dicator lights up. If so, fail- procedure in the correct sewhen turned on?ure to start may be due to quence, see "Using the dryer". an incorrect program selection procedure. They can be found on the data plate located below the drum opening. 16 Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the dryer. Quick Guide 1. Turn on the dryer and load the laundry 2. Select a program ^ Press the "On/Off" button to turn on the dryer. ^ Turn the program selector clockwise or counterclockwise to the desired program. Select the Buzzer to signal the end of the program (if desired) ^ Press the "Door" button to open the door. Make sure that there is enough space in the drum for clothes to tumble freely. To prevent fabric damage, check that laundry will not be caught in the closed door. ^ Close the door with a firm swing - do not push it shut. ^ Press the "Buzzer" button. Quick Guide 4. At the end of a program The "Anti-crease / Finish" indicator will light. ^ Turn the program selector to "Finish". ^ Press the "Load size" button in for a full load. Press the "Load size" button out for a small load. Start the program ^ Press "Door" and remove the laundry. ^ Press "START". ^ Clean the lint filter. ^ Press the "On/Off" button to turn off the dryer. Quick Guide Program COTTONS Extra dry Fabric For drying laundry that will be stored away, such as linens or seasonal clothing. Knitted cotton fabrics that may shrink, e. g. [. . . ] 312" (8. 00 m) 25 INSTALLATION INSTRUCTIONS Wall vent duct Dryer top view 1. Flexible foam gasket A flexible foam gasket must be used if the tumble dryer is directly connected to the wall vent. inch 4 1/4" 4" 23 1/2" 28 /2" 1 cm 10. 8 10 60 72. 5 26 INSTALLATION INSTRUCTIONS Example 1 Connection of the rigid metal pipe to the dryer (side view). Connect the ducting ^ Attach the ducting to the vent. ^ Move the dryer close to its final position. [. . . ]