User manual MIELE T1526

[. . . ] Operations Manual for the T 1526 Vented Dryer It is essential to read these operating instructions before installing or using the machine to avoid the risk of accident, or damage to the machine. ö M. -Nr. 04 979 250 Contents Contents Guide to the machine. 5 Your contribution to the environment . 27 2 Guide to the machine Guide to the machine 1 2 3 4 5 Supply cable with plug Control panel Drum door Exhaust connection (left or rear) Four height-adjustable legs 3 Guide to the machine Pushbuttons ­ Door This button is used to open the door (does not stay pushed in). [. . . ] Permanent press shirts, table cloths, pillowcases etc. cotton/synthetics, which are to be pressed. Items which you want to "fluff". 7 lbs With blended fabrics consisting of wool and synthetics, consult the manufacturer's instructions, as the wool component may cause the fabric to matt and shrink. load Special instructions Normal 7 lbs Hand iron 7 lbs TIMED DRYING warm This cycle will run for the full 20 minutes, even if the clothes are dry sooner. - cool air 13 lbs 13 Cleaning and care Cleaning and care Cleaning the lint filter The lint is collected by the lint filter in the door. Clean the filter after every program. Cleaning the dryer Before cleaning the tumble dryer, disconnect the machine from the power supply. The dryer can be cleaned using soapy water or a mild non-abrasive detergent (not scouring powder) and dried with a soft cloth. The drum may be cleaned using a suitable stainless steel cleaner following the manufacturer's instructions. Do not hose down the machine or use abrasive cleaners. Grip the filter by the recessed handle and pull up to remove. Any lint remaining in the hollow part of the door can be removed through the gap at the bottom. The lint filter can be rinsed with water if necessary. Dry the lint filter before putting it back in place. 14 Problem solving guide Problem solving guide Electrical appliances should only be repaired by qualified personnel. Incorrectly repaired machines may put the user at risk. There are, however, minor problems which can be corrected without contacting the Service Department. What to do if, . the tumble dryer fails to start when turned on?Check whether the "On" indicator is lit. If so, failure to start may be due to an incorrect program selection procedure. If the "On" indicator lamp does not illuminate, check that: Remedy . Repeat the program selection procedure in the correct sequence, as outlined in the "Program Selection" chapter. ­ The "ON/OFF" button is depressed. ­ The machine is plugged in and the fuse or circuit breaker has not tripped. [. . . ] The Additional Duct Length Factor is then added to the actual duct length to give the Effective Duct Length. A larger diameter duct also helps to reduce friction. Duct diameter should therefore be increased for longer duct runs. Measure the actual straight duct length needed. [. . . ]