User manual MIELE T1565C

[. . . ] Operations Manual for the T 1565 C Condenser Dryer It is essential to read these operating instructions before installing or using the machine to avoid the risk of accident, or damage to the machine. ö M. -Nr. 03 719 530 Contents Contents Guide to the machine. 6 Your contribution to the environment . 8 OPERATING INSTRUCTIONS Loading the machine . [. . . ] a cooling-down phase lasting 8 mins. ) or fluffed in a cool air cycle for 15 minutes. ­ Door This button is used to open the door. ­ ON/OFF When the machine is turned on, the "On" indicator lamp illuminates if the door is closed. When the door is open, the drum is illuminated. ­ Buzzer When activated, the buzzer will sound as the drum rotates during the anticrease cycle. 10 Program selection To select a program A program can only be selected after the machine is turned on. To change a program during drying: Set the program selector to the desired program. The new program will start from the beginning. The following tables (on the next two pages), list the range of applications for the different programs. Set the desired program by turning the program selector either clockwise or counterclockwise. The program status will be stored for 30 minutes in the event of a power failure. Correct procedure: 1 Press the "On/Off" button. Items which you want to "fluff". 5. 5 lbs With blended fabrics consisting of wool and synthetics, consult the manufacturer's instructions, as the wool component may cause the fabric to matt and shrink. load Special instructions Normal 5. 5 lbs Hand iron 5. 5 lbs TIMED DRYING warm This cycle will run for the full 20 minutes, even if the clothes are dry sooner. - cool air 11 lbs 13 USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS Emptying the condensed water containe Depending on your type of installation, the condensed water will either be pumped to a drain, or collected in the condensed water container, located in the upper left corner of the machine. The container will hold approximately 1 gallon of water. The container should be emptied after each drying program. Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: ­ The "Empty out container" indicator lamp will light ­ The buzzer will sound ­ The drying program will stop ­ The machine will enter the cooling down cycle To empty the container: Hold the cap open while emptying the container. When the container is empty, push it into its recess until it clicks into place. Note: The water collected in the container has been distilled by evaporation and can be used in a steam iron or humidifier, for example. The following points should be remembered: As a precautionary measure, the water should be passed through a fine sieve or coffee filter in order to strain out any small particles of lint which might otherwise cause damage. Pull out the container with both hands. 14 USER MAINTENANCE INSTRUCTIONS Cleaning the lint filters The lint is collected by the lint filter in the door. Clean the filter after every program. These filters should only be removed for cleaning with water. Dry the filters before putting them back in place if they were rinsed. Grip the filter by the recessed handle and pull up to remove. Any lint remaining in the hollow part of the door can be removed through the gap at the bottom. Remove any accumulated lint from the filters in the door opening. [. . . ] This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Electrical connection This installation should be done by an experienced and qualified person, in most cases a licensed electrician, in accordance with local codes and regulations. This dryer is supplied with a 5 ft long, 12/4 AWG cord and a NEMA 14-30 P plug. It should be connected to a 120/240 V (208 V), 60 Hz AC power supply. [. . . ]