User manual MIELE T366

[. . . ] Rather than just throwing these materials away, please ensure they are offered for recycling. rendered useless and the cable cut off directly behind it to prevent misuse. See the "Warning and Safety" section of this booklet for further details. Energy saving tips To avoid unnecessarily long drying times and high consumption of energy: ­ Make sure that your laundry is thoroughly spun before drying. The higher the spin, the greater the savings that can be made in energy and time during drying. [. . . ] The indicator light for the Low temperature button will flash and a key symbol 0-§ will appear in the display. To deactivate the lock Before you begin, first ensure that: ­ The tumble dryer is switched off. ^ The procedure is the same as for activating the lock. Carry out steps A to E as described previously. At step E the indicator light for the Low temperature button will stop flashing and the key symbol 0-§ will go out. The electronics are no longer locked. 20 Cleaning and care Cleaning the fluff filter The fluff which is created by the drying process is collected in the fluff filter in the door. Clean the filter after each drying cycle*. * Always check the fluff filter if the Clean out airways indicator light comes on. Cleaning whilst dry Tip: You can also use a vacuum cleaner to remove the fluff. ^ Use your fingers to remove the fluff from the surface of the filter. ^ Remove any fluff from the hollow part of the door opening. You could also use a cleaning brush which is available as an optional extra from your Miele dealer or the Miele Spare Parts Department, or use a vacuum cleaner. To delete the fault message: ­ Open and close the door. The Low temperature indicator light starts flashing after the dryer has been switched on and a appears in the display. The programme stops and Cooling down or Finish flashes in the display. The buzzer sounds. You will need to deactivate the system lock before the dryer can be used (see "Electronic system lock"). ­ Switch the dryer off and then on again. If the programme stops again and or flashes again there is a fault. Contact the Miele Service Department. No obvious cause. 23 Problem solving guide Problem The Clean out airways indicator light comes on. Possible cause This indicator light comes on to warn you that the dryer is not working efficiently. Possible cause: The fluff filter is clogged with fluff or with detergent residues. Remedy ­ Cleaning the fluff filter is usually all that is required. However, if the Clean out airways indicator light does not go out after you have cleaned the filter, then also check all the possible causes described under "The drying process goes on too long or even switches off". To switch off the indicator light: ­ Open and close the door. The vent ducting may be very ­ See "Installation - venting" long, which does not regarding calculating constitute a fault. [. . . ] F Switch the machine off with the I-On/0-Off button. The setting you have selected is now stored in memory. You can change it again at any time. 49 Programmable functions Keypad tone An audible tone sounds each time a button is pressed. Follow steps A to F to programme and store in memory. [. . . ]