User manual MIELE TOUCHTRONIC PREMIER PLUS

[. . . ] Operating instructions Touchtronic Premier Plus To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 431 300 Contents IMPORTANT SAFETY INSTRUCTIONS MESURES DE SÉCURITÉ IMPORTANTES Caring for the environment Energy saving washing . 9 Guide to the dishwasher Wash cabinet . 11 Before using for the first time To open the door . [. . . ] All progam indicators will light and the "Start/Stop" indicator will flash. ^ Select a wash program using the program selection buttons (16). The selected program indicator will light and the "Start/Stop" indicator will flash. ^ Refer to the "Program guide" for details. The run time of the program selected will appear in the time display (18) in hours and minutes. The "Time left" indicator will light. ^ Select "Delay Start" or "Top Solo" if desired. ^ Press the "Start/Stop" button (21). Important program steps could be omitted (e. reactivating the water softener). 30 Operation Waterproof System All Miele dishwashers are specially designed to shut off the water intake and drain the wash cabinet in the rare event of an internal water valve failure. For this feature to be active, the machine must be "On" (not necessarily running), and the door must be closed. At the end of a program The "End" indicator will light and 0 will appear in the time display (18). ^ Open the dishwasher door slightly to allow the dishes to cool before unloading. It is advisable to turn off the water supply if the dishwasher will not be used for a period of time (e. g. while vacationing). Program sequence indicator (14) The current step of a wash program is indicated by a program sequence indicator (14). Time display (18) The run time of a program is shown in hours and minutes in the time display before a program starts. The "Time left" indicator will be lit. The time displayed may vary with the same program. This is due to the water inlet temperature at each intake, the load size and degree of soiling of dishware being washed. Each time a program is selected the electronic unit takes into account the new conditions and calculates the time required. This figure is shown in the time display. 31 Operation Interrupting a program A program is interrupted as soon as the door is opened. If the door is closed, the program will continue from where it was interrupted. Changing a program If the selected program has not yet started: ^ Press the "Start/Stop" button (21) for at least one second. ^ Press the program button (16) of the desired program. ^ Select "Delay start" or "Top Solo" if needed (see "Additional features"). ^ Press the "Start/Stop" button (21). [. . . ] They will damage the surface. Plastic All plastic surfaces and the control panel can be cleaned with warm water and liquid dish soap applied with a soft sponge. Wipe dry using a soft cloth. Cleaning the door and door seal ^ Wipe the door seal with a damp cloth to remove any food particles. ^ Food residue and spilt liquids should be wiped from the sides of the dishwasher door. These are outside of the wash cabinet and are not cleaned by water from the spray arms. , Do not use too much water when cleaning the controls. [. . . ]