User manual MIELE W1119I

[. . . ] Operating instructions Washer W 1119 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 874 961 Contents IMPORTANT SAFETY INSTRUCTIONS . Activate the program lock (if necessary) . 21 Adding/removing laundry during a wash program . [. . . ] Remove the siphon tube from the fabric softener compartment § and rinse under warm water. Clean the pipe on which the siphon tube is attached. Replace the siphon tube. , Do not use chemical solvents, abrasive cleaners, glass or all purpose cleaners. These can damage plastic surfaces and other parts. ^ Pull out the detergent drawer as far as it will go. Press down on the red release lever and pull the drawer out of the machine. ^ Clean the detergent drawer with warm water. ^ Clean the siphon tube. 24 Washer care Cleaning the water inlet filters The washer has two water inlet filters to protect each inlet valve. These filters should be checked and cleaned if necessry every 6 months. This may have to be done more frequently with some water supplies. , Inspect the hose regularly. The hose must be in good condition to withstand high water pressure. The hose should be replaced if there are cracks in the surface, or if it has been otherwise damaged or cut. Cleaning the inlet hose filter ^ Turn off the water valve. ^ Unscrew the inlet hose from the valve by turning he connector counterclockwise using a wrench if necessary. Cleaning the filter in the inlet valve ^ Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. ^ Using needle nose pliers, remove the plastic filter (see illustration). Both filters must be put back in place after cleaning. ^ Remove the rubber seal, 1, from the connector. ^ Using needle nose pliers, grasp the plastic filter, 2, and pull it out of the hose connector. ^ Clean the filter under running water and carefully remove any large particles. Replace the filter and seal and reconnect the hose. ^ Slowly turn on the valve and check for leaks. If water leaks, tighten the bolt. 25 Washer care Clean the drain pump Occasionally, small objects (buttons, coins, etc. ) may become trapped in the lint trap. If the machine does not drain completely, the lint trap should be checked to ensure that it is free of foreign objects. ^ Open the detergent dispenser drawer. ^ Remove and clean the lint trap. ^ Remove the tool. The lint trap lid is visible when the access panel is opened. ^ Check that the impeller (in the back of the chamber) rotates freely by spinning with your hand. [. . . ] If the water pressure is below 15 psi (1 bar), there will not be enough water available for a complete fill. The water intake hoses are equipped with screen filters. Do not remove these filters except for cleaning. Tips for a hot water connection ­ The hot water temperature from the hot water valve must not exceed 140°F; the ideal temperature is 130°F. [. . . ]