User manual MIELE W1203-WASHER

[. . . ] Operating instructions Washer W 1203 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 874 980 Contents IMPORTANT SAFETY INSTRUCTIONS . 20 Adding/removing laundry during a wash program . 24 Cleaning the filter in the inlet valve . [. . . ] The "Child lock" indicator flashes. Turn off the washer with the "On/Off" button. To deactivate the Child Safety Lock Repeat steps 1. The "Child Lock" indicator goes out. 22 Washer care , Before cleaning the appliance, ^ Clean the siphon tube. disconnect the power supply by unplugging the unit or manually tripping the circuit breaker. Cleaning the washer ^ Clean the exterior of the washer with a mild solution of non-abrasive detergent or soap and water. ^ Clean the drum with a stainless steel cleaner specially formulated for use in a washing machine. This type of cleaner is available from Miele's Technical Service Department. Cleaning the detergent drawer Detergent residue should be cleaned out regularly. 1. Remove the siphon tube from the fabric softener compartment § and rinse under warm water. Clean the pipe on which the siphon tube is attached. 2. Replace the siphon tube. , Do not use chemical solvents, abrasive cleaners, glass or all purpose cleaners. These can damage plastic surfaces and other parts. ^ Pull out the detergent drawer as far as it will go. Press down on the red release lever and pull the drawer out of the machine. ^ Clean the detergent drawer with warm water. 23 Washer care Cleaning the water inlet filters The washer has two water inlet filters to protect each inlet valve. These filters should be checked every 6 months and cleaned, if necessary. (This may need to be performed more frequently with some water supplies). , Inspect the hose regularly. The hose must be in good condition to withstand high water pressure. The hose should be replaced if there are cracks in the surface, or if it has been otherwise damaged or cut. Cleaning the inlet hose filter ^ Turn off the water valve. Cleaning the filter in the inlet valve ^ Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. ^ Using needle nose pliers, remove the plastic filter by pulling on the bar (see illustration). Both filters must be put back in place after cleaning. ^ Unscrew the inlet hose from the valve by turning the connector counterclockwise using a wrench, if necessary. ^ Remove the rubber seal, 1, from the connector. ^ Using needle nose pliers, grasp the plastic filter, 2, and pull it out of the hose connector. ^ Clean the filter under running water and carefully remove any large particles. Replace the filter and seal and reconnect the hose. ^ Slowly turn on the valve and check for leaks. 24 Washer care Cleaning the drain pump Occasionally, small objects (buttons, coins, etc. ) may become trapped in the lint trap. [. . . ] If the water pressure is below 15 psi (1 bar), there will not be enough water available for a complete fill. The water intake hoses are equipped with screen filters. Do not remove these filters except for cleaning. Tips for a hot water connection ­ The hot water temperature from the hot water valve must not exceed 140°F; the ideal temperature is 130°F. [. . . ]