User manual MIELE W1930

[. . . ] Operating instructions Washer W 1930 To prevent accidents and machine damage, read these Operating Instructions before installation or use. U M. -Nr. 05 047 720 Contents Guide to the machine. 5 Preparation for use Operating Instructions USER MANTENANCE Instructions INSTALLATION INSTRUCTIONS Technical data . 46 2 Guide to the machine a Supply cable b High pressure intake hoses c Flexible drain hose, with detachable swivel elbow d Detergent dispenser drawer e Control panel f Drum door g Access panel for drain pump and filter h Four height adjustable feet i Panel for emergency door release (door hinged right) and for drainage (door hinged left or right) j Panel for emergency door release (door hinged left) 3 Guide to the machine Detergent dispenser drawer Compartment i - for the pre-wash. [. . . ] If the connection drips and cannot be tightened any further, the gasket may need to be replaced. Always replace the intake filter after cleaning it. 24 Problem solving guide Any work done on the electrical components of this appliance should only be performed by a qualified technician in accordance with all local and national codes and regulations. Unauthorized repairs may result in personal injury and machine damage. What to do if, . The "ON" indicator lamp has not lit up. Remedy . . Check that. . : ­ the door is properly closed. The "Check indicator lamps are flashing? ­ the fuse or circuit breaker has not tripped. ­ Turn the program seThere is power and the lector to the "Finish / "ON" indicator lamp is on, but the program selector Start" position. has not been turned to ­ Select a program. the "Finish / Start" position. " The "Check p" indicator ­ The inlet valve is not opened far enough. lamp is flashing, and the program has started. ­ The inlet hose is The water inlet is blocked. The "Check q" indicator ­ Clean the drain pump lamp is flashing. ­ Has the drain hose been installed too high?(max drain height = 4 feet) 25 Problem solving guide What to do if, . the "Pre-wash", "Main wash" or "Rinse 1-2" indicator lamp is flashing?The "Rinse & hold" indicator lamp is flashing?The "Final spin" indicator lamp is flashing? Cause . . There is an internal problem. Remedy . If the indicator lamp starts flashing again, call the Service Dept. Select a spin speed setting. The spin speed selector has been set to "Without final spin". The final spin has not ­ Redistribute the launtaken place. [. . . ] A new program can be selected as soon as the "On" lamp is the only one remaining lit. High water level (only in "Cottons" rinses) Where rinse results are particularly important (e. g. Soap allergies). 5th Rinse in the "Cottons" program For soft water areas (up to 135 ppm calcium carbonate). In soft water areas, a higher water level can be selected in addition to a 5th rinse cycle, if required. Extra water intake through compartment i A 10 second water intake through compartment i during the main wash can be added. Additional rinse in Rapid wash For soft water areas. The functions described above can be programmed by the owner using the steps shown on the following pages. 41 Programmable functions Step 1: Turn off the machine, close the door, and release all pushbuttons. [. . . ]