User manual MIELE W1930I

[. . . ] Operating instructions for the W 1930i Washing Machine To prevent accidents and reduce the risk of damaging the machine, read the Operating Manual before installing or using the machine. ö M. -Nr. 04 612 680 Contents Contents Guide to the machine. 5 Preparation for use Help protect our environment . 6 Operating Instructions Economical usage . [. . . ] Carefully unscrew the inlet hose from the valve by turning the connector counterclockwise using a wrench if necessary. Remove the rubber seal from the connector. Inspect the inlet hose regularly. The hose should be replaced if there are small cracks in the surface, or if it has been otherwise damaged or cut. If a replacement is necessary, use only a genuine Miele inlet hose as other hoses may burst under pressure. To clean the filter in the inlet valve: Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. Using needle nose pliers, grasp the plastic filter and pull it out of the hose connector. Clean the filter under running water and carefully remove any large particles. Replace the filter and seal and reconnect the hose. Slowly turn on the valve and check for leaks. Using needle nose pliers, withdraw the plastic filter by pulling on the bar (see illustration). Rinse under water to clean, and then replace. The two filters - one at the pressure hose/valve connection and one at the inlet connection to the solenoid valve - must not be removed. 24 Problem solving guide Problem solving guide Any work done on the electrical components of this appliance should only be performed by a qualified and trained person in accordance with all local and national codes and regulations. Unauthorized repairs may result in personal injury and damage to the machine. What to do if, . The "ON" indicator lamp has not lit up. Remedy . . Check that. . : ­ the door is properly closed. ­ the fuse or circuit breaker has not tripped. There is power and the "ON" indicator lamp is on, but the program selector has not been turned to the "Finish / Start" position. The "Check p / q" indicator lamps are flashing?The "Check p" indicator lamp is flashing, and the program has started. The water inlet is blocked. ­ Turn the program selector to the "Finish / Start" position. ­ Select a program. ­ The inlet valve is not opened far enough. ­ The inlet hose is kinked. ­ The water pressure is too low. Call the Service Dept. The "Check q" indicator lamp is flashing. The drain is blocked. ­ Clean the drain pump and lint trap. ­ Has the drain hose been installed too high?(max drain height = 4 feet) 25 Problem solving guide Problem solving guide What to do if, . the "Pre-wash", "Main wash" or "Rinse 1-2" indicator lamp is flashing? Cause . [. . . ] A new program can be selected as soon as the "On" lamp is the only one remaining lit. The functions described above can be programmed by the Customer using the steps shown on the following pages. There are other programmable functions which are reserved for Miele Service Engineers. They are not normally activated, and require access to internal machine components. Where rinse results are particularly important (e. g. [. . . ]