User manual MIELE W1986

[. . . ] Operating instructions Washer W 1986 To prevent accidents and machine damage, read these instructions before installation or use. U M. -Nr. 05 665 081 Contents IMPORTANT SAFETY INSTRUCTIONS . 15 Using the "Starch" program . Activate the program lock (if necessary) . [. . . ] Press the "Heavy Soil" button and hold the button pressed in during steps 3. Turn the program selector slowly in a clockwise motion to "COTTONS/ 140 °F". Turn the program selector slowly in a counterclockwise motion to "End". To deactivate the safety lock Repeat steps 1. The "Door Lock" indicator goes out. Turn the program selector slowly in a counterclockwise motion to the "DELICATES/cold" position. The "Door Lock" indicator (lower right of control panel) flashes. Release the "Heavy Soil" button. Turn the program selector to "End". Turn off the washer using the "On/Off" button. 21 Washer care , Before cleaning the appliance, disconnect the power supply by unplugging the unit or manually tripping the circuit breaker. Cleaning the washer ^ Clean the exterior of the washer with a mild solution of non-abrasive detergent or soap and water. ^ Clean the drum with a stainless steel cleaner specially formulated for use in a washer. This type of cleaner is available from Miele's Technical Service Department: (part # 00 077 927) ^ Clean the dispenser compartments and the fabric softener duct. Cleaning the detergent drawer Detergent residue should be cleaned regularly. ^ Remove the siphon tube from the fabric softener compartment § and rinse under warm water. , Do not use chemical solvents, ^ Pull out the detergent drawer until it stops. Press the red release lever down and pull the drawer out of the machine. abrasive cleaners, glass or all purpose cleaners. These can damage plastic surfaces and other parts. Do not use a hose to clean the washer. 22 Washer care Cleaning the drain pump and lint trap Occasionally, small objects (buttons, coins, etc. ) may become trapped in the lint trap. If the machine does not drain completely, the lint trap should be checked to ensure that it is free of foreign objects. ^ Place a 2 quart capacity container underneath the drain tube. ^ Turn the lint trap lid counterclockwise 2 - 3 times. About 2 quarts of water will drain out of the hose. ^ To clean the lint trap, remove the tool from behind the detergent dispenser drawer. If the main drain hose is clogged, additional water will remain in the machine. In this case, tighten the lint trap lid and empty the container. , Caution: If the laundry has been washed at a high temperature, the water draining out of the machine will still be hot. Allow it to cool before proceeding. ^ Open the lint trap door. 23 Washer Care Once the flow of water stops: ^ Remove the lint trap lid. [. . . ] The washing machine has 1/2" pressure hoses with 3/4" female hose thread connections. If there is no water hookup, contact a plumber to install a connection. Make sure that the sealing ring is seated properly on the hose connector. Only replace the hose with a genuine Miele hose or with a hose able to withstand up to 145 psi (10 bar) pressure. [. . . ]