User manual MIELE WT 945

[. . . ] Operating instructions Washer-dryer WT 945 S WPS To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed or used for the first time. G M. -Nr. 05 876 080 Contents Caring for the environment . 5 Disposal of your old appliance or machine . 11 "Spin" button with indicator lamps . [. . . ] Overloading can cause unnecessary wear and tear to the laundry and give a disappointing drying result. E Close the drum door Make sure that no garments are caught between the drum door and seal. F Open the stopcock 32 DRYING Programme selection G Select a drying programme The programmes are described in the "Drying programme charts". Additional options for the drying programmes H Select an additional option "Thermospin" ^ Turn the programme selector to the required drying programme. ^ For minimum iron fabrics which are being dried in the TIMED DRYING programme, you should always select the Drying/ Low temp. The sensor drying programmes for COTTONS and MINIMUM IRON include a thermospin process. This process uses heat during a pre-tumbling spin to break the bond between the water and the clothes being dried. This reduces drying times and the amount of energy required for drying (one of the spin speed indicator lamps will light up). Exception: The thermospin will not be carried out if the additional function Drying/Low temp. has been selected. ^ Press the "Spin" button repeatedly until the indicator lamp for the spin speed you want for the thermospin comes on. Exception: The thermospin will not be carried out if TIMED DRYING has been selected. The temperature is reduced during the drying programme. ­ This is suitable for particularly sensitive fabrics (care symbol r) e. g. can be selected for any programme where it is required. The thermospin will not take place. 33 DRYING Delay start I Select Delay start Exception: Delay start J Start the programme The START indicator lamp will flash as soon as a programme can be started. After the programme has started the START indicator lamp will light up constantly. The door cannot be opened if the temperature is higher than 70°C. If this is the case the locked indicator light will flash when the Door button is pressed. Exception: when the programmable function "Opening the door at high temperatures" has been activated. ^ Press the Delay start button repeatedly until the required delay start period shows up in the display (from i to 9 hours). The chosen time will start to count down hour by hour. The programme will then start automatically. To cancel "Delay start": ^ Press the Delay start button once when is showing in the display, or ^ Switch the appliance off using the I-ON/0-OFF button. [. . . ] E The following will appear in the display: 0 = Programmable function off (de-activated) or i = Programmable function on (active) , Warning: The water in the machine will be very hot and could cause burning or scalding. The machine is delivered with the programmable function switched off. Follow steps A to G to programme and store in memory. The programmable functions are activated with the help of the additional option buttons and the WASHING programme selector. Before you begin, first ensure that: ­ the machine is switched off. [. . . ]