User manual MINELAB QUATTRO MP

[. . . ] table of contents www. minelab. com 1. 2. INTRODUCING THE QUATTRO MP Multi-frequency-Full Band Spectrum (FBS) Technology Quattro Technical Specifications 3 4 5 6 6 6 7 7 8 9 9 10 10 11 11 12 12 12 14 16 16 16 p1 ASSEMBLING YOUR DETECTOR Step 1 - Connecting the Search Coil Step 2 - Shaft Assembly Step 3 - Connecting the Shaft Assembly Step 4 - Armrest Assembly 3. 7. 6. SEARCH COILS BATTERIES Removal/Replacement of Battery Pack Recharging NiMH Battery Pack Battery Indicator HEADPHONES QUICK START CONTROL PANEL Power (On/Off) Display Meter Detect Modes Menu/Select +/Accept/Reject Pinpoint table of contents www. minelab. com 7. 7. 14. Noise Cancel 16 17 18 18 18 19 19 19 21 21 23 23 24 25 26 MENU SETTINGS Sensitivity Volume Threshold Noise Cancel Contrast Trash Density DISCRIMINATION Modifying Discrimination Scale DETECTOR SOUNDS USING YOUR QUATTRO MP TROUBLESHOOTING GLOSSARY OF TERMS PRE-SET SETTINGS p2 1. [. . . ] The advantages of Double D coils are very good ground cancelling abilities, and very good ground coverage, as the coil has an even detection range along its entire length. Because of this, the operator is only required to slightly overlap each sweep, to ensure all targets at maximum depth are recovered. The 10. 5" coil is excellent for general searching. There is an optional 8" coil available that provides greater sensitivity to small targets, and improved performance in high trash areas. Both coils are epoxy filled, so they can be submersed in water, but care must be taken to ensure the control box remains dry. To replace the search coil: 1. Undo control box camlock and disconnect the coil cable from the control box. Separate the two shaft assemblies by releasing the shaft camlock and sliding the lower shaft out. Loosen the plastic nut and remove the bolt from the yoke bracket. Gently pull the coil cable from inside the yoke/lower shaft. Carefully feed the new coil cable into the yoke and lower shaft. Continue to feed the cable into the shaft until the connector is visible at the top of the shaft. Note: It may be easier to pull the cable through the lower shaft using a length of string or cord. Once this is completed you should be able to see approximately 4 inches (100mm) of cable between the coil yoke and the search coil. Using other chargers may damage your battery and will void the product warranty. Wall/Mains Charger The NiMH battery pack is sold in the discharged condition. It is necessary to charge it before operating the detector. Plug the mains charger into the wall socket. Insert the mains charger plug into the socket at the tapered end of the battery pack. Leave for about 18 hours to fully charge. Remove the battery charger plug from the battery pack, ready for use. Note: You may find that the first couple of times you charge your battery, you may not achieve the full hours of operation. The batteries will reach their full capacity after several recharge cycles. Car Charger 4. Insert the car charger plug into the cigarette lighter socket of your vehicle. [. . . ] Target Icons Similar to the ID numbers, the Quattro MP will also indicate the likely target type located, using a select number of generic icons (F). At times the meter may display two icons at once, indicating that the characteristics of the target located is similar to that of a number of targets. Note: Target icons only appear in the COIN and COIN/JEWELRY modes. p13 7. control panel www. minelab. com 7. 2. 5. [. . . ]