User manual MINOURA HYPERMAG1200-LW

[. . . ] · The trainer is manufactured to precise standards. · "Magturbo" is the trademarks of Minoura Co. , Ltd. Tandems may be used if balanced correctly. Replace your quick release skewer to the supplied one and install the supplied coupling protector cap onto the right side coupling when you use the trainer. [. . . ] Do NOT remove the round metal plates from inside the rubber feet when fitting. NOTE: If the both legs don't touch the floor at same time and if one side of the leg is still being lifted up slightly, pull up the leg upward strongly then place the trainer on the floor again. 2 Open both couplings by turning the right side hub handle (see Fig. Do not over-loosen the couplings, otherwise the knob or the hub handle may become unthreaded inside the frame. Insert the left side of the skewer (quick release lever side) into the left side coupling, and adjust the rotation of the coupling so the skewer lever sits securely in the large cut-out (see Fig. This will prevent damage to the skewer during use. Hold the bike firmly by hand and turn the hub handle clockwise until the coupling comes into contact with the right side skewer nut. Apply the Mag unit to the tire by lifting up it temporally to know the wheel position. If the tire touches either left or right side platic housing of the Mag unit (see Fig. D), you must adjust the Mag unit position by loosening two bolts beneath the Mag unit. Do not forget to tighten the bolts firmly after adjusting. D) Turn the micro adjust knob clockwise to bring the drive roller into contact with the rear tire. If the tire is compressed about 3mm by the roller, stop turning the knob. WARNING: Too much or too little contact between the tire and the roller can cause premature tire wear and possibly damage the drive roller. C) 6 ! Using The Mag Unit The Magturbo unit has 7 different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) and can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter device. The rider may also adjust the load force by shifting up or down among his gears, depending on the level desired. We recommend that you start with a medium to low load force and gradually work up, increasing force as muscled warm up. -3- Increasing Load Force To increase the load force, turn the lever on your thumb shifter device toward the "H" symbol. E) To decrease the load force, turn the lever on your thumb shifter device toward the "L" symbol. Be sure the lowest selection is not zero load, there still be a small level of force. HOW TO INSTALL THE REMOTE LEVER You can install the remote lever on anywhere the diameter is between 22. 2mm (7/8") and 31. 8mm (1-1/4") like as on the handlebar. 1 2 Fully loosen the knob bolt on the plastic holder until it stops then push down the bolt to open the holder. [. . . ] If so, please adjust the tension with the following steps; Nut Plastic Cap Cable 1 2 3 Set the remote shifter lever at "H" position. Remove the remote shifter device from the handlebar and straighten the cable. Remove the plastic cap located on the bottom of the cable. J) Wire Tension Adjusting Screw (Fig. [. . . ]