User manual MINOURA MAG-850

[. . . ] MAG-850 indoor bicycle trainer RESOLUTION DIAGRAM coupling cover (fix side) coupling (R) coupling cover (move side) hub handle main frame flywheel cover flywheel flywheel side inner case leg rubber cap frame rubber cap mag side inner case alloy rotor outer cover drive roller connecting plate mount plate foot pedal WARRANTY PARTS 400-4511-00 400-4502-00 400-4611-00 400-4602-00 400-4604-00 400-1243-00 400-4509-00 : : : : : : : Dial Mag resistance unit Dial outer cover Remote Mag resistance unit Remote outer cover Hub handle Coupling (right side) Foot pedal 400-4503-00 400-4504-00 400-4505-00 400-4506-00 400-4605-00 400-4606-00 400-4607-00 400-4608-00 : : : : : : : : Mag side inner case Flywheel side inner case Flywheel cover Drive roller Frame rubber cap Leg rubber cap Coupling cover (move side) Coupling cover (fix side) IMPORTANT NOTES · Read all instructions including the back page of the POP card board carefully before use. · Keep the manual handy at all times. · Do NOT use trainer for any other purpose than instructed. [. . . ] Accidents may occur from cracked or damaged couplings. When using the trainer, place it on a flat surface for safe training. Do not over tighten the hub-clamp handles. Over-tightening may cause damage to the trainer or bicycle frame. The clamp handles should be a snug and secure fit. Before use, make sure all bolts and nuts are securely fastened. Keep away from small children, and keep hands and feet away from spinning rollers and wheels at all times. Open the legs fully to get maximum stability. !! USING THE MAGTURBO UNIT The Magturbo unit has 7 different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) and can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter device. The rider may also adjust the load force by shifting up or down among his gears, depending on the level desired. We recommend that you start with a medium to low load force and gradually work up, increasing force as muscled warm up. Increasing Load Force To increase the load force, move the white lever on the Mag unit toward the (H) symbol. A) If your Mag unit is a remote control type, turn the lever on your thumb shifter device toward the (H) symbol. C) L Decreasing Load Force To decrease the load force, move the white lever on Mag unit toward the (L) symbol. (see Fig. B) Be sure the lowest selection is not zero load, there still be a small level of force. If your Mag unit is a remote control type, turn the lever on your thumb shifter device toward the (L) symbol. [. . . ] Hold the adjusting screw with your right hand and push it towards the direction of the outer cable, then adjust the nut with your left hand to make the wire tension properly. Nut Plastic Cap Cable Wire Tension Adjusting Screw (Fig. D) FOR MORE INFORMATION MINOURA JAPAN HEAD OFFICE 1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN Phone +81- (0)584-27-3131 / Fax +81- (0)584-27-7505 E-mail: minoura@minoura. jp http:// www. minoura. jp MINOURA NORTH AMERICAN CENTER FOR RESEARCH, DEVELOPMENT & MARKETING 1996 East Avenue, Hayward, CA 94541-5454 U. S. A. Phone 510-538-8599 / Fax 510-538-5899 E-mail : MinouraUSA@ATTglobal. net Made & Quality Controlled in Japan Copyright © 2002 Minoura Japan, All Rights Reserved. [. . . ]