User manual MINOURA MAGTURBO ERGO

[. . . ] ! Please obey warning signs. Use two-wheeled bicycles only. Tandems may be used if balanced correctly. Remove all oils and moisture from the drive roller before use. Keep both hands on handlebars at all times and maintain a normal riding position. Check the couplings supporting the rear hub for damage and cracks. [. . . ] Loosen the Knob Bolt enough until the wheel can be placed without touching the Drive Roller on Mag resistance unit. You may need to manually move the drive roller. Install the rear hub between the couplings. C) While holding your bicycle, tighten the Hub Handle in a clockwise direction until you see the couplings come in contact, and engage the heads of your QR lever. 1 2 3 (Fig. C) 4 Stop tightening the handle after the couplings have engaged the QR. You should NOT be able to move the bicycle without also moving the trainer. If the bicycle moves within the couplings AT ALL, continue to tighten the handle until you see no movement of the bicycle within the couplings. Please be sure not to tighten the couplings past the point that the bicycle does move within the couplings. Over tightening can cause both your bicycle and trainer to sustain damage. Be sure to check this each time you use your trainer. -4- 5 Tighten the knob bolt until it starts to move the drive roller towards your tire. to use your hand to assist in this process. Once the drive roller comes in contact with your tire, tighten the knob bolt another half or one more turn. This should provide optimal contact with your tire. This is a guidleine and adjustment one way or the other may be necessary in order to provide the best contact. D) Be sure too much or too few roller pressure to the tire will cause a problem such as wearing down so quickly. (Fig. D) -5- USING THE MAGTURBO UNIT The Magturbo unit has seven different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) and can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter device. [. . . ] H) If you cannot shift to either the lowest (L) or the highest (H) position, it is possible that the inner wire of the remote shifter cable is too long and the wire tension is loose. If so, please adjust the tension with the following steps; 1. Set the remote shifter lever at "H" position. Remove the remote shifter device from the handlebar and straighten the cable. [. . . ]