User manual MINOURA P-60 CLOSET-CYCLIST

[. . . ] CC-100 "CLOSET-CYCLIST" instruction manual Please read this instuctions carefully before use. Thank you for purchasing Minoura CC-100 "Closet-Cyclist" bike display stand. [. . . ] You will need a M4 Hex wrench and a 13 mm spanner in order to assemble Closet-Cyclist completely. HOW TO ASSEMBLE YOUR CLOSET-CYCLIST 1 Screw the foot adjuster to the nut located on each leg end. 3 Install the Reinforcement Arms between the Lower Pillar and the Front Legs by tightening the M6x14 bolts for the pillar side, and M6x30 bolts for the leg side. After installing the Reinforcement Arms, tighten the M8x55 bolts firmly. Wrong step may make you unable to install the Reinforcement Arms. (Fig. A) 2 Insert four M8x55 bolts into the holes on the bottom of the Lower Pillar, then put through the legs. The long leg is for rear section, and the short legs are for front section. Be sure to fit the legs to the shape of the horrow of the bottom plate. Lower Pillar Rear Leg Bottom Plate Reinforcement Arm Front Leg (Fig. B) (Fig. C) 4 Place the Connecting Plates at the top of the Lower Pillar. Connect the Upper Pillar to the lower pillar then tighten the M6x14 bolts firmly. Now the base frame is completed. Upper Pillar Completed Closet-Cyclist Connecting Plate Lower Pillar (Fig. D) 5 Next, you'll install the Front Wheel Hook and the Rear Wheel Support Arm to the pillar. Wrap the stainless band around the pillar, insert the end of the band between another end and the square nut. [. . . ] Front Wheel Hook Rear Wheel Support Arm (Fig. F) MADE IN JAPAN Copyright 2002 Minoura Co. , Ltd. [. . . ]