User manual MINOURA P-600AL

[. . . ] Be careful about the stability when taking off the bike. · You should setup P-600AL along a wall to prevent falling backward problem. Do not install the bike on the backside of P-600AL. Upper Hook Stainless Band Clip 1 Main Pillar Install both right and left Front Legs to the Leg Base Plate with the supplied M6x35 bolt (type-A), Flat washer, Collar and M6 Nylon nut. [. . . ] Make sure the Main Pillar must cover on the bracket, not placing beside the bracket. D) Pillar Base Plate Rear Leg (Fig. B) M6x40 Bolt (type-A) Leg Base Plate Right Side Front Leg Height Adjuster 3 Required Tools for Assembling 1 x M5 Hex Wrench 1 x 10mm Spanner 1 x 13mm Spanner Bolt Type Recognition Type-A: plain type bolt (Fig. D) 5 Type-B: with Spring Washer MADE IN JAPAN Attach the Backside Leg on the back of the Main Pillar, then tighten with the supplied two M6x18 bolts (type-B) temporarily. Please note that you will tighten M6x18 Bolt these bolts firmly after installing the Reinforcement Bars. E) 6 Raise up the Reinforcement Bars and attach to the Main Pillar with the supplied M6x70 bolt (type-A), Plastic Shim, M6 flat washer and M6 Nylon nut. After installing the Reinforcement Bars, adjust the Backside Leg height to touch the floor all together, then tighten the M6x18 bolts on the Backside Leg firmly. Each bike requires both hooks and they are fully position adjustable. Find out the best position to hang down your bike most efficiently. To install the Stainless Band Clip, follow the steps below; 1) Once disassemble the Stainless Band Clip. 2) Open the band and wind it around the Main Pillar. The end with a welded nut must be inward. Make sure that both ends fit each other. 4) Attach the Plastic Bracket onto the band. It should be snapped in. Plastic Shim M6x70 Bolt Washer (type-A) Washer Reinforcement Bar Nylon Nut 7 (Fig. F) ! If the inside band end with welded nut has been angled against the bolt, you won't be able to screw the bolt in. [. . . ] K) For More Information If you have any questions or need help, you should contact the dealer where you purchased or the Minoura distributor in your country first. The distributor can be found on our web site. Only when you cannot get enough service, you can contact us. MINOURA JAPAN (for ALL customers) 1197-1 Godo, Anpachi Gifu 503-2305 Japan Phone +81-584-27-3131 Fax +81-584-27-7505 Email minoura@minoura. jp Web www. minoura. jp MINOURA NORTH AMERICA (for U. S. [. . . ]