User manual MINOURA V270

[. . . ] Failure to do so will cause a problem that the legs will not be positioned in same height. Remove the alloy sleeve and plastic washers. 7 4 Plastic Washer Alloy Sleeve Plastic Washer End Plug Pivot Bolt U-Leg The center guide bolt is intentionally loosened in the package condition. Check each leg moves smoothly. Insert the alloy sleeve into the selected hole, and put the plastic washers on both sides. -2- ! You do not need to disassemble the center guide bolt. Just tighten. How To Install Mag Unit & Foot Step Required Tools: 1 x 5mm Hex Wrench (supplied) 1 x 10mm Spanner (not supplied) Mag Resistance Unit The Mag resistance unit and Foot Step now need to be installed to the frame. [. . . ] This step is not always required and once fixed in the proper position, you should not need to adjust again. Once adjusted to fit your bike, simply operate the Quick Hub Handle Lever for a proper fit every time. ! 1 2 3 4 5 First, loosen the red Lock Ring by turning it counter-clockwise. The left side coupling is actually a bolt/ coupling combination. Turn the coupling to adjust the position. Raise the Quick Hub Clamp Lever up to retract the right side coupling. Insert the left side hub end (quick release lever side) into the left side coupling cone. In this position, place the other side of the bike into the right side (rear cog side) coupling cone. Make sure your derailleur cable goes OVER the coupling. Now, push down (lower) the Quick Hub Clamp Lever until it fully engages the skewer or axle nut. Make sure the Quick Clamp Hub Lever is lowered into its locked position and cannot be lowered any further. The frame may appear slightly open but this is normal. If the frame seems to be opened too widely, re-mount your bike following the instructions. Failure to do so could damage your bike and/or the trainer. Lock Ring Left Side Coupling Quick Hub Clamp Lever Right Side Coupling Quick Release Skewer 6 7 8 9 Now, grab the saddle of your bike and rock the bike back and forth to make sure your bike is securely in the trainer. Your bike should not move independently of the trainer where it is attached. Tighten the red Lock Ring firmly to fix the left side coupling position. -5- How To Use Foot Pedal The Foot Pedal is a convenient device to engage/release the drive roller to/from the rear tire quickly, and it keeps the proper pressure of the drive roller to the tire without adjusting everytime you use the V270. To maintain the tire life as long as possible, you should adjust correctly. [. . . ] How to reduce the resistance level Twist the shifter lever toward "L" symbol. ! "L" is not zero resistance. There is still some resistance at "L" level due to the roller compression to the tire. How To Adjust Remote Cable If you cannot shift at L or H position, it's time to adjust the remote cable. 1) Set the remote shifter lever at "H" position and straighten the cable. [. . . ]