User manual MINOX DC 1011

[. . . ] FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Follow the same steps to capture subsequent images in the sequence. Finish the sequence by pressing the SET button after the last image has been recorded. [ ] Anti-Shake Mode The anti-shake function works according to the luminance of the target object. This function uses special image data processing for getting high sensitivity of CCD. High sensitivity can use higher shutter speed compared with normal mode, so it reduces influence of hand shaking. From the resolution point of view, it becomes worse than normal mode. Maximum size of image becomes 6 megapixels (2816 x 2112). Slide the mode switch to [ ] and set the mode dial to [ ]. Compose the image, press the shutter button down halfway, then press it down fully. EN-46 Recording a Subject onto an Existing Background Image (Pre-Shot) Pre-Shot helps you get the background you want, even if you need to ask someone else to record the image for you. Basically, Pre-Shot is a two-step process. You compose the background you want and press the shutter button, which causes a semi-transparent image of the background to remain on the monitor screen. Ask someone else to record a shot of you against your original background, telling him/her to compose the image by using the semi-transparent monitor screen image as a guide. The camera stores the image produced by step 2 only. Depending on how the image is actually composed in step 2, its background may not be exactly the same as the one you composed in step 1. Freeze the background on the monitor screen. Record the image, using the background on the monitor screen as a guide. Only the second image is recorded. EN-47 1. Slide the mode switch to [ ] and set the mode dial to one of the photography modes, except for [ ], [ ] and [ ]. Select [Capture Mode] with the / buttons, and press the SET button. Select [Pre-Shot] with the / buttons, and press the SET button. Compose the background you want on the monitor screen, and then press the shutter button to temporarily record it as a reference image. This operation causes a semi-transparent image of the background to appear on the monitor screen, but the displayed image is not actually saved in camera memory. Now you can stand in front of the background and ask someone else to snap your picture, using the semi-transparent background on the monitor screen as a composition guide. [. . . ] Insert a new memory card, or delete unwanted files. Format the memory card in this camera before its first use or when it was used other than this camera. Adjust the brightness of the LCD monitor in the menu. Wipe clean with a soft, dry cloth or lens paper. [. . . ]