User manual MINOX DCC ROLLEIFLEX AF 5.0

[. . . ] When discarding a battery, insulate the poles with a piece of tape, etc. To prevent possible contact with metallic objects that could lead to ignition and/or explosion. insert battery correctly in the camera. Wrong polarity (+/-) could cause explosion and/or leakage of battery, possibly leading to hazards and injuries. [. . . ] Push the card further to make it spring back. Set the cover as shown and slide it toward the camera front (Arrows) till it clicks in place. * The cover can be removed from the camera. Hold both sides of Viewfinder cover as shown and lift the cover up Å. Close the hood while pressing inward the hinges on both sides of the hood as shown Ç. When the battery is almost drained, the battery icon gives a warning signal by blinking ( ). (Replacing the battery at this point with a new one is recommended. ) Then, before the battery is completely drained, the icon flashes ( ) and the power is automatically turned off. * When you do not use the camera for a long time, be sure to remove the battery from the camera in order to prevent battery drain. Strap through a Strap bracket and let the strap go through the loop as shown. Brackets (right and left) put the straps together and adjust length as shown. Turning on and off the power Push the Power switch button to turn the camera on. Another push on the button turns power off. Power will be cut when the power source button is depressed continuously while the power source button is turned on. * When the camera is idle for longer than 60sec, power will automatically be turned off. * You cannot shift to Playback mode when no image is stored. * Turn the handle before shooting each picture. * Focusing may take longer time under low light conditions. * Image may be captured even when the shutter button is not fully depressed, but crank handle may not be released in this case. When composition is decided depress the shutter button all the way. When the shutter release button is depressed, the "FOCUSING" signal is displayed once. focusing is completed when the display disappears , and the camera is in a focus-lock condition. [. . . ] Except for high-frequency fluorescent lamp(s), stripes may appear across images captured under normal fluorescent lamp(s) at the incompatible frequency. Even set at the correct frequency, stripes may appear under strong fluorescent lighting. When a mini SD memory card is not loaded, the situation is indicated in this way, and the power is turned off automatically. The camera, when left without operation for longer than 60sec, automatically activates Auto power-off circuitry to turn power off. [. . . ]