User manual MITSUBISHI LT-4260

[. . . ] LCD Television System LT-4260 (LCD Display model: L423FR) Owner's Guide visit our website at www. mitsubishi-tv. com RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user of the presence of uninsulated "dangerous voltage" within the product's enclosure that may be sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Connecting a Satellite receiver with component Video Connections. 32 Connecting a Computer Directly to LCD Display LCD Display Side Panel When connecting a PC to the LCD Television System, connect the PC directly to the LCD display. Do not connect the PC to the HD-6000. LCD Display Back Panel (section detail) to PC or Macintosh® back panel to PC or Macintosh® back panel Figure 7. Connecting Computer Connecting a Computer (Figure 7) · Your Mitsubishi LCD display supports VGA, SVGA, XGA, and WXGA PC resolutions only. See Appendix B: Supported PC Resolutions, P. Connect a Mini D-sub 15-pin (RGB) cable from the LCD Display Back panel to PC or Macintosh® back panel. Connect a PC Audio Cable (or 1/8" stereo mini jack cable) from the LCD Display side panel to PC or Macintosh back panel. The Mini D-sub 15-pin (RGB) and 1/8" (3. 5mm) stereo mini jack cables can be found at your local electronics store. Connecting your computer to this LCD will allow you to display your computer's images. Since this monitor is widescreen (16:9 aspect ratio), the display configuration will vary depending on which video card or driver(s) you use. You may also need to use a Macintosh® adapter when connecting to some Macintosh® computers. 33 How Connections Affect the PIP (Picture-In-Picture) and POP (Picture-Outside-Picture) and DW (Double Window) This information only applies when the HD-6000 is not connected to the LCD Display. To see a picture in the PIP, POP or Double Window you may need to select an input source. If other video equipment is connected, you may be able to view these input sources as the PIP/POP. When connecting your LCD Display, it is important to understand which main picture and PIP/POP input sources can and cannot be used together. The table on this page shows which inputs can and cannot be used together and the limitations they may have. If you press the INFO button it will display the current Input signal (480i, 480p, 720p, or 1080i), format, and sleep time. See Operation of PIP and POP, page 60, for operating instructions. PIP/POP (sub) Main Input Component 480i, 480p, 720p, 1080i HDMI PC Input Component HDMI 480i, 480p, 720p, 1080i OK OK OK OK PC OK OK OK OK OK OK OK OK OK OK OK OK 34 This page intentionally left blank 35 Chapter . . 4 Remote Control Functions Overview of the TV Layer Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Sleep Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Use With Other A/V Products . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 Operation of PIP, POP and Double Window . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Remote Control Functions: Overview of the TV Layer Buttons Overview 18-FORMAT: Change the shape and size of the main TV picture. 19-REC: Manually record with a VCR or recordable DVD. 20-REW/REV: Rewind or reverse search with a VCR, reverse scan with a DVD, or skip reverse with a CD. [. . . ] Contact your nearest authorized MITSUBISHI service center, whose name and address can be obtained from your MITSUBISHI dealer, by writing at the address provided below, calling MDEA at the 800-3322119, or by using the support feature of our website at www. Mitsubishi-tv. com. Warranty service will be provided in your home or, if required, at an authorized service shop, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. Actual service labor will be provided without charge. [. . . ]