User manual MITSUBISHI LVP-X80

[. . . ] LCD Projector User Manual X80 MODEL LVP-X80U EN ­ 1 ESPAÑOL ITALIANO DEUTSCH FRANÇAIS ENGLISH CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. NOTE: SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. WARNING Use the attached specified power supply cord. If you use another power-supply cord, it may cause interference with radio and television reception. [. . . ] (Adjust to the vertical SHUTTER(U) lines of the input signal for normal setting. ) SHUTTER(L) PLL . . . . . . . . . . . . . . . . . . . . . . Use to adjust the image when skewed on top. Select AUTO SHUTTER(LS) for normal setting. Use to adjust the image when its motion does not run smoothly. Use to adjust the image when the noise etc. Use to adjust the image when the noise etc. Use to adjust the image when the noise etc. Use to adjust the image when the noise etc. appears on right side of image. 0 0 0 0 AUTO AUTO 0 0 0 0 User memory for signal setting This projector can memorize the maximum of 2 signal menu settings. Select MEMORIZE in the SIGNAL menu, and press the ENTER button. Press the $ or % button to select the memory which you wish to record (USER 1 or USER 2). Initialite the setting which has been changed (Default) Select RESET in the SIGNAL menu, and press the ENTER button. · When initializing, selection buttons will not work for about 2 - 18 seconds. Select the user setting Select MEMORY CALL in SIGNAL menu, and press the $ or % button to select the memory (USER 1 or USER 2). Select DELETE in the SIGNAL menu, and press the ENTER button. Press the $ or % button to select the memory which you wish to reset (USER 1 or USER 2). The recorded setting will be reset. EN ­ 17 ENGLISH Picture adjustment Adjusting the image You can adjust the picture by using the IMAGE menu. Opt 3. Press the $ or % button to select USER }. · When you select sRGB or STANDARD, you can not adjust the color balance of the color. Press the { or } button to select the desired color. · If you wish to adjust the color intensity of the image, select SATURATION. Press the $ or % button to adjust the color balance of the color. [. . . ] It may not operate when changing the signal. Operation POWER ON POWER OFF INPUT COMPUTER INPUT VIDEO ASCII !" _r1 _v1 HEX 21h 22h 5Fh 72h 5Fh 76h 31h 31h · POWER OFF command will not work for 1 minute after the power is turned on. · POWER ON command will not work for 1 minute after the power is turned off. [Example] Set the input signal to COMPUTER (' 'is for ASCII code) Sending commands from the PC etc. [. . . ]