User manual MITSUBISHI MSZ-FD09NA

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] For example, the current mode is SB MODE OFF, the key is pressed twice within a 3 second time frame, the SB MODE will change to SB MODE1 and so on. Degauss: Eliminates the buildup of stray magnetic fields which alter the correct scan of the electron beams and affect the purity of the screen colours, focus and convergence. When activated, your screen image will jump and waver a bit as the screen is demagnetized. Caution: Please allow a minimum of 20 minutes to elapse between uses of the Degauss Control. Each colour setting is adjusted at the factory to the stated Kelvin. If a setting is adjusted, the name of the setting will change from Kelvin to Custom except sRGB mode. Red, Green, Blue: Color Control System decreases or increases the monitor's red, green or blue colour guns depending upon which is selected. You can not change Red, Green and Blue colours, brightness and contrast individually. colour Temperature Adjustment: Adjusts the colour temperature of the screen image. Geometry Controls Geometry Controls Menu The Geometry controls allow you to adjust the curvature or angle of the sides of your display. sides In/Out (pincushion): Decreases or increases the curvature of the sides either inward or outward. oSM Turn Off: The OSM controls menu will stay on as long as it is in use. In the OSM Turn Off sub-menu, you can select how long the monitor waits after the last touch of a button for the OSM controls menu to disappear. the preset choices are 5 thru 120 seconds. OSM Lock Out: This control completely locks out access to all OSM controls functions except Brightness and Contrast. When attempting to activate OSM controls while in the lock out mode, a screen will appear indicating that OSM controls are locked out. IPM System Off Mode: Enable: The IPM System works normally and all stages of energy savings are utilized. disable: The Off Mode of the IPM System is not used. NOTE: For standard systems and graphics boards, keep the factory setting at ENABLE. NOTE: Do not keep the monitor on when `No Signal' is applied. This could cause image burn-in on the screen due to the `No Signal' message being displayed. EdgeLock Control: Operating your monitor at a nonstandard timing may cause images to appear darker than normal or have color distortion. [. . . ] When operating the Diamond Pro 930SB with the AC 100 - 240 V power source in EU countries except UK, use the power cord supplied. Cleaning Your Monitor A special coating is provided on the glass (CRT) surface of this monitor to reduce a reflection and static electricity on the glass surface. due to the delicate coating on the glass surface , use a lint-free , non-abrasive cloth (cotton or equivalent) and a nonalcohol , neutral , non-abrasive cleaning solution to minimize dust. If the screen requires more than a light cleaning, apply a soft neutral detergent and water directly to a soft cloth and use it upon wringing water, to clean the glass surface. [. . . ]