User manual MITSUBISHI MSZ-FD12NA

[. . . ] SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. WARNING Use the attached specified power supply cord. If you use another power supply cord, it may cause interference with radio and television reception. Use the attached RGB cable and the shielded LAN cable with this equipment so as to keep interference within the limits of an FCC Class B device. This apparatus must be grounded. When using the projector in Europe: COMPLIANCE NOTICE This Projector complies with the requirements of the EC Directive 2004/108/EC "EMC Directive" and 2006/95/EC "Low Voltage Directive". [. . . ] When the keystone adjustment takes effect, the resolution decreases. In addition, stripes may appear or straight lines may bend in images with complicated patterns. They are not due to product malfunctions. Noise may appear on the screen during the keystone adjustment because of the type of the video signal being projected and the setting values of the keystone adjustment. In such cases, set the keystone adjustment values in the range where the image is displayed without noise. When the keystone adjustment is carried out, the image may not be displayed correctly because of the type of input signal. Press / . Press / · Magnifying and searching for details If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for navigating the picture. Using the remote control Press MAGNIFY +/- to display the Zoom bar. Press MAGNIFY + to magnify the center of the picture. Press the key repeatedly until the picture size is suitable for your need. Real: The image is projected as its original resolution, and resized to fit within the display area. For input signals with lower resolutions, the projected image will display smaller than if resized to full screen. You could adjust the zoom setting or move the projector towards the screen to increase the image size if necessary. You may also need to refocus the projector after making these adjustments. 16:9 picture 3. 4:3 picture 16:9 picture 4. 4:3: Scales an image so that it is displayed in the center of the screen with a 4:3 aspect ratio. This is most suitable for 4:3 images like computer monitors, standard definition TV and 4:3 aspect DVD movies, as it displays them without aspect alteration. 4:3 picture EN-27 ENGLISH Selecting the aspect ratio 5. Full: Scales an image to full screen size (16:10). The image is projected to fit all over screen. (MSZ-FD12NA only) 4:3 picture 16:9 picture 16:10 picture EN-28 Optimizing the image The projector is preset with several predefined picture modes so that you can choose one to suit your operating environment and input signal picture type. To select a operation mode that suits your need, you can follow one of the following steps. · · Press MODE/ENTER on the remote control or projector repeatedly until your desired mode is selected. Go to the PICTURE > Setting menu and press / to select a desired mode. ENGLISH EN-29 Selecting a picture mode Picture modes for different types of signals The picture modes available for different types of signals are listed below. 1. 2. 3. 4. 5. Brightest mode: Maximizes the brightness of the projected image. [. . . ] The lens cover is still closed. Remedy Adjust the focus of the lens using the focus ring. Adjust the projection angle and direction as well as the height of the unit if necessary. Open the lens cover. Remote control does not work Cause The battery is out of power. There is an obstacle between the remote control and the projector. [. . . ]