User manual MITSUBISHI NM-C110

[. . . ] This unit complies with the requirements of the EC Directive 2004/108/EC, "EMC Directive". The requirements for the susceptibility according to EN 55024 and the requirements for interference according to EN 55022 are observed for the operation on residential areas, business, light industrial premises and in small scale enterprises, inside as well as outside of the building. All places of operation are characterized by their connection to the public low voltage power supply system. Warning This is class A product. In a domestic environment this product may cause radio Interference in which case the user may be required to take adequate measures. i Note: This symbol mark is for EU countries only. [. . . ] ASP (Advanced Simple Profile) is available up to the 4CIF resolution and 8000kbit/s. GOV size The GOV size can be adjusted from 1 to 1000 stages, and the default is 30. If users want to have a high quality of fast image one by one, please decrease the value. For the purpose of general monitoring, please do not change a basic value. Such act may cause a problem to the system performance. For the details of GOV setting, please contact the service center. -7- AE & AWB Setting For more detailed settings, users can set the white balance and automatic exposure control. It is possible to designate the basic value according to the types of light or set it to a full automation mode. White Balance Control White Balance Mode When it comes to the White Balance Mode, users should select an illumination mode similar to that of general weather. If users are not familiar with mode selection, please select the automatic mode. White Balance range This function is to prevent the White Balance from leaning to a certain color too much. If users want to prevent a certain color from getting thick too much at night or dark places, it would be effective to select the "Wide" mode. In general cases, please select the "Normal" mode. Set user calibration Users are allowed to set the White Balance of their own. If users press the "Calibration" button after having a white background or a sheet of white paper in front of the NETWORK CAMERA, the White Balance will be adjusted. Auto Exposure Control Enable Low shutter : Users can use the Low Shutter mode in low light environments. Select using -Electronic shutter: For using manual lens. Flicker-free : It removes flicker in the 50Hz power zone. ( When it checks this, the shutter speed is fixed. So it uses `Dc-Iris Lens', it promotes. ) -8- 3. 3. 2 Audio Setting Basic Setting Users can use a microphone and speaker by using the audio function. Audio Setting Compression type Users can increase a transmission rate or enhance a tone quality by selecting an audio compression mode. The PCM 16-bit implements the best tone quality, while the PCM 8-bit corresponds to that of radio sound. Sample rate If a sample rate is low, the tone quality will go down but the transmission rate will go up. If a sample rate is high, the tone quality will be better, but the transmission rate will drop. Please, adjust its rate in accordance with a network status or purposes. Audio Input Source Users can select either MIC input or LINE input, but cannot use both at once. Input Volume Users can control the input volume by adjusting the microphone volume. [. . . ] Backup Save a setting value that users enter to the NETWORK CAMERA, to a user PC. Restore Import and apply a setting value saved to a user PC. - 21 - Program Support Information Troubleshooting When problems occur during operation, please consult with an installer. Server Report If its support is requested, please attach a server report. Log & Report Users can check the system log and server report. Logs Reports Users can check the log for Network Camera operation by clicking the < Logs >. Users can check a server report by clicking the < Server Report >. Users can check a parameter by clicking the < Parameter List >. - 22 - Program Information The following website will provide the support information for the NETWORK CAMERA system information and operation. 3. 4 Help The Help information window will be provided as a popup window so that users can open and read it without a need for log-in. [. . . ]