User manual MITSUBISHI NM-C130FD

[. . . ] This unit complies with the requirements of the EC Directive 2004/108/EC, "EMC Directive". The requirements for the susceptibility according to EN 55024 and the requirements for interference according to EN 55022 are observed for the operation on residential areas, business, light industrial premises and in small scale enterprises, inside as well as outside of the building. All places of operation are characterized by their connection to the public low voltage power supply system. Warning This is class A product. In a domestic environment this product may cause radio Interference in which case the user may be required to take adequate measures. ii Note: This symbol mark is for EU countries only. [. . . ] If it is not connected in the Internet, from the CD-ROM install the ActiveX Controller by manual operation. 4. 2 Real-Time Monitoring The monitoring screen comes in four screen modes like D1, 640 X 480, 320 X 240, and 160 X 120. Users are allowed to select the most suitable one out of those modes. Please, adjust the mode in accordance with your PC specifications and monitoring purposes. - 24 - In case of real-time monitoring with the Web Browser, one Network Camera will be connected to just one Web Browser. However, this case is not suitable for monitoring various screens at the same time. If users are to monitor various images at the same time, please contact your dealer. HTTP tunnel mode When the screen is not indicated, check. (Notice: "unicast mode" only it is applied. ) If users are to control the volume of a microphone and speaker connected to a user PC, they should adjust the user PC volume regardless of the microphone and speaker volume control set in Network Camera. 4. 3 NETWORK CAMERA Setting The Network Camera setting is divided into video, audio, alarm, and system settings. And the detailed screen will be provided for each setting. 4. 3. 1 Video Setting The video setting is classified into Basic, MPEG-4. The Basic menu includes a setting menu for realtime monitoring. Its setting only is enough to complete a setting for viewing the monitoring screen. The detailed setting menu is able to perform screen sizing, filtering, compressibility, and brightness control. - 25 - Basic Setting Image Appearance Resolution It enables users to determine a basic screen size when having an access through the Web Browser or PC program. The screen size control comes in four modes like D1, 640 X 480, 320 X 240, and 160 X 128. Users can reset the selected screen size anytime while monitoring the screen on a real-time basis. Image filter The image filter control enables users to reinforce the image quality in a strong or weak way. The default is "disabled. " Compression When it is necessary to adjust a smooth transmission status according to network situations, users can increase the compressibility to carry out the network transmission stably. On the other hand, when it is necessary to maintain a detailed monitoring screen by enhancing the image quality, users can do so by decreasing the compressibility. In ease case, please adjust this function according to the network status and monitoring purposes. The default is 2000(Kbps). - 26 - BCS Adjust Brightness The screen brightness can be adjusted from 0 to 255 stages, and the default is 128. The brightness may differ depending on the equipment and PC monitor status. Contrast The screen contrast can be adjusted from 0 to 127 stages, and the default is 73. The contrast may differ depending on the equipment and PC monitor status. Saturation The screen saturation can be adjusted from 0 to 127 stages, and the default is 64. [. . . ] Isolate the problem to the specific piece of equipment in the system and refer to the equipment manual for further information. The camera is not working properly and the surface of the camera case is hot. Camera number does not match the number on PC Program or Web browser. Frame rate decrease A connection is cut-off at short intervals AREA TO CHECK 1. [. . . ]