User manual MITSUBISHI PD-4225S

[. . . ] Owner's Guide Mitsubishi Plasma TV PD-4225S Technically Anything is Possible® © Copyright 2003, Mitsubishi Digital Electronics America Warning Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. NOTE TO CABLE/TV INSTALLER: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the National Electric Code (U. S. A. ). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical. REGULATORY INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Use the DEVICE button on the remote control to select Video (Rear). Operate the corresponding external equipment. Refer to external equipment operating guide. DVD Setup How to connect 1. Connect the DVD video outputs to the COMPONENT INPUT jacks (Y, PB, PR) and connect the DVD audio outputs to the AUDIO INPUT jacks. How to use (FACTORY INSTALLED) 1. Use the DEVICE button on the remote control to select Component. Refer to the DVD player's manual for operating instructions. · Component Input ports To get better picture quality, connect a DVD player to the component input ports as shown below. The TV Component Ports Y Y Y Y Y PB PR DVD Player Video Output Ports Pr Pb B-Y R-Y Cb Cr PB PR DTV Setup - To watch digitally broadcasted programs, purchase and connect a digital set-top box. - This TV supports HDCP (High-bandwidth Digital Content Protection) protocol for DTV (480p, 720p, 1080i) modes. (FACTORY INSTALLED) How to connect 1. Use the TV's COMPONENT (Y, PB, PR) INPUT, RGB, or MONITORLINK/DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. How to use 1. (Refer to the owner's manual for the digital set-top box. ) 2. Use the DEVICE button on the remote control to select Component, RGB or MonitorLink. or Digital Set-top box or Owner's Manual 25 NOTE: Not all cables shown are included with the TV. They are available at most consumer electronics stores. Monitor Out Setup The TV has a special signal output capability which allows you to hook up a second TV or monitor. Connect the second TV or monitor to the TV AV OUTPUT. See the Operating Manual of the second TV or monitor for further details regarding that device's input settings. NOTE: · Component, RGB-PC/DTV 480p/720p/1080i, S-video input sources cannot be used for Monitor out. PC Setup - This TV provides Plug and Play capability, meaning that the PC adjusts automatically to its settings. The TV sends configuration information (EDID) to the PC using the Video Electronics Standard Association (VESA) Display Data Channel (DDC) protocol. How to connect 1. To get the best picture quality, adjust the PC graphics card to a 640x480, 60Hz setting. Use the TV's RGB INPUT port for video connections. Then, make the corresponding audio connections. If using a sound card, adjust the PC sound as required. How to use 1. [. . . ] Actual service labor will be provided without charge. Proof of purchase date from an authorized MITSUBISHI dealer is required when requesting warranty service. Present your sales receipt or other document which establishes proof and date of purchase. THE RETURN OF THE OWNER REGISTRATION CARD IS NOT A CONDITION OF WARRANTY COVERAGE. [. . . ]