User manual MITSUBISHI PD-4265

[. . . ] Owner's Guide Mitsubishi Plasma Display PD-4265 & PD-5065 IMPORTANT SAFETY INSTRUCTIONS (PD-4265/PD-5065) Read before operating equipment Read these instructions. Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] SHARPNESS: Changes the picture's sharpness. Adjust for natural colored skin, background, etc. Adjusting the computer image Only the contrast and brightness can be adjusted when a computer signal is connected. Restoring the factory default settings Select "DEFAULT" under the "PICTURE MODE" settings. EXIT RETURN EXIT RETURN Information PICTURE MEMORY Settings OFF: Picture memory not used. MEMORY1 to 6: There are six available picture memory locations. Setting the memory · Use the and button to select the desired memory location, MEMORY1 to MEMORY6. · Use the and buttons to select "SET", then press the MENU/ENTER button. Resetting the memory Use the and button to select the desired memory location, MEMORY1 to MEMORY6, then use the and buttons to select "RESET", and finally press the MENU/ENTER button. The memory is cleared, and "--" is displayed in the "INPUT", "SIGNAL" and "NOTE" columns. Inputting notes · Use the and buttons to select "NOTE", then press the MENU/ENTER button. Use the and button to select the character. Use the EXIT button to delete the character at the cursor position. · When you have finished inputting the note, press the MENU/ENTER button. 18 Reducing noise in the picture Use these settings if the picture has noise due to poor reception or when playing video tapes which have poor picture quality. Example: Setting "NR-3" Press MENU/ENTER button to access MAIN MENU. Use the buttons to select the PICTURE menu and then press the MENU/ENTER button. Use the buttons to select the NR setting. Use the buttons to change NR. PICTURE : OFF PICTURE MEMORY CONTRAST BRIGHTNESS SHARPNESS COLOR R TINT : OFF NR : MIDDLE COLOR TEMP. :2 GAMMA : AUTO LOW TONE : 0% SET UP LEVEL COLOR ADJUST : ON FILM MODE : NORMAL PICTURE MODE SEL. EXIT RETURN G NR : NR-3 Information NR * "NR" stands for Noise Reduction. * This function reduces noise in the picture. Types of noise reduction There are three levels of noise reduction. The effect becomes stronger as the number increases (in the order NR-1 NR-2 NR-3). [. . . ] THE RETURN OF THE OWNER REGISTRATION CARD IS NOT A CONDITION OF WARRANTY COVERAGE. However, please return the Owner Registration Card so that we can contact you should a question of safety arise which could affect you. This Plasma Display Panel uses a revolutionary technology, gas plasma, to create the screen image. This technology creates the image using small dots, or picture elements (pixels). [. . . ]