User manual MITSUBISHI PEFY-P18

[. . . ] Use the attached RGB cable and RS-232C cable with this equipment so as to keep interference within the limit of a FCC Class B device. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/ Data Processing Equipment, ANSI/NFPA 75. When using the projector in Europe: COMPLIANCE NOTICE This Projector complies with the requirements of the EC Directive 89/336/EEC "EMC Directive" as amended by Directive 92/31/EEC and 93/68/EEC, and 2006/95/ EC "Low Voltage Directive". [. . . ] (See page 30. ) Use to adjust the color tint of the projected image. (See page 30. ) Use to adjust the sharpness of the projected image. (See page 30. ) Use to adjust the position (height) of the projected image. Select an iris mode depending on the projected image. (See page 31. ) Use to reduce noise and roughness in the image when noisy video signal is input. CTI 0-5 Use to correct smeared color boundaries. INPUT LEVEL ±5 For analog signal input: The input level of video signal differs among devices to be connected. High input level causes solid white in displayed image and low input level causes displayed image to get dark. Use this menu to adjust the input level of analog video signal. ENHANCED / For digital signal input: When a digital signal is input, ENHANCED and NORMAL NORMAL are switchable. (See page 16. ) 3 options Select the AV MEMORY to which you save the current setting. · When the lamp mode is switched, the projected image may flicker. · Do not change the setting of LAMP MODE frequently. · To cancel the test pattern, press any button. EN-26 Menu operation (continued) 3. FEATURE menu opt. FEATURE ASPECT PASSWORD FUNCTION MENU POSITION MENU DIMMER CINEMA MODE ? AV MEMORY 1 AUTO DISPLAY INPUT 1. OFF AUTO AUTO AUTO OFF English OK VIDEO SIGNAL SETUP SCART INPUT AË LANGUAGE RESET ALL 3. FEATURE menu ITEM ASPECT SETTING AUTO 4:3 16:9 ZOOM1 ZOOM2 STRETCH FUNCTION Select to change the aspect ratio automatically depending on the input signal. Select to project images with an aspect ratio of 4:3. Select to project images with an aspect ratio of 16:9. (Linearly stretched. ) Select to enlarge and project images of CinemaScope size. Select to enlarge and project images of Vista size. Select to enlarge to 16:9 and project of the images with an aspect ratio of 4:3. [. . . ] · If the resolution and frequency of your computer aren't shown on the table, find the compatible resolution and frequency by changing the resolution of your computer. · This projector doesn't support 480p signals from video devices having 4 lines (R, G, B, CS*) or having 5 lines (R, G, B, H, V). * : Composite Sync EN-43 Specifications (continued) Connectors SERIAL (D-SUB 9-pin) 5 9 1 6 10 15 Pin No. 1 2 3 4 5 6 7 8 9 Name ­ TXD RXD ­ GND ­ ­ ­ ­ I/O ­ IN OUT ­ ­ ­ ­ ­ ­ COMPUTER IN/COMPONENT VIDEO IN (Mini D-SUB 15-pin) 5 1 6 11 Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Spec. [. . . ]