User manual MITSUBISHI PEFY-P24 NMSU-E

[. . . ] Use the attached RGB cable and RS-232C cable with this equipment so as to keep interference within the limit of a FCC Class B device. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/ Data Processing Equipment, ANSI/NFPA 75. When using the projector in Europe: COMPLIANCE NOTICE This Projector complies with the requirements of the EC Directive 89/336/EEC "EMC Directive" as amended by Directive 92/31/EEC and 93/68/EEC, and 73/23/ EEC "Low Voltage Directive" as amended by Directive 93/68/EEC. [. . . ] ADVANCED MENU OK (See page 32. ) AV MEMORY AV MEMORY1 SAVE Use to adjust the contrast of the projected image. (See page 30. ) Use to adjust the brightness of the projected image. (See page 30. ) Use to adjust the color temperature. (See page 31. ) Use to adjust the color thickness of the projected image. (See page 30. ) Use to adjust the color tint of the projected image. (See page 30. ) Use to adjust the sharpness of the projected image. (See page 30. ) Select according to the screen size. Use to adjust the position (height) of the projected image. Select an iris mode depending on the projected image. (See page 31. ) Use to reduce random noise. (See page 32. ) Use to reduce mosquito noise. Select when viewing images projected from the behind of the screen with the projector installed on the ceiling. Select when viewing images from the front with the projector installed on the ceiling. Choose ON to output the trigger output signal (12 V) from the TRIGGER terminal when the lamp illuminates. Select to show the test cross hatch pattern. Use to enable or cancel the FOCUS LOCK and ZOOM LOCK. Use to enable or cancel the LENS SHIFT LOCK. Use to reset the position of the lens to the factory setting. AUTO POWER ON AUTO POWER OFF OFF / 5 - 60min SPLASH SCREEN ON / OFF BACK COLOR BLUE / BLACK IMAGE REVERSE OFF MIRROR INVERT MIRROR INVERT TRIGGER OUT ON / OFF TEST PATTERN CROSS HATCH LENS LOCK ZOOM/FOCUS LOCK LENS SHIFT LOCK LENS SHIFT RESET · When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW about one minute after turn-on. · When the lamp mode is switched, the projected image may flicker. · Do not change the setting of LAMP MODE frequently. · To cancel the test pattern, press any button. EN-26 Menu operation (continued) 3. FEATURE menu opt. FEATURE ASPECT PASSWORD FUNCTION MENU POSITION MENU DIMMER CINEMA MODE ? AV MEMORY 1 AUTO DISPLAY INPUT 1. [. . . ] · If the resolution and frequency of your computer aren't shown on the table, find the compatible resolution and frequency by changing the resolution of your computer. · This projector doesn't support 480p signals from video devices having 4 lines (R, G, B, CS*) or having 5 lines (R, G, B, H, V). * : Composite Sync EN-43 Specifications (continued) Connectors SERIAL (D-SUB 9-pin) 5 9 1 6 10 15 Pin No. 1 2 3 4 5 6 7 8 9 Name ­ TXD RXD ­ GND ­ ­ ­ ­ I/O ­ IN OUT ­ ­ ­ ­ ­ ­ COMPUTER IN/COMPONENT VIDEO IN (Mini D-SUB 15-pin) 5 1 6 11 Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Spec. [. . . ]