User manual MITSUBISHI PLFY-P-NAMU-E

[. . . ] Use the attached RGB cable with this equipment so as to keep interference within the limits of an FCC Class B device. This apparatus must be grounded. When using the projector in Europe (only for WD510U): COMPLIANCE NOTICE This Projector complies with the requirements of the EC Directive 2004/108/EC "EMC Directive" and 2006/95/EC "Low Voltage Directive". The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small-scale enterprises, inside as well as outside of the buildings. All places of operation are characterized by their connection to the public low voltage power supply system. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75. [. . . ] Select this setting to increase the density of black. Select this setting to lower the density of black. · When 7. 5% is set, the brightness is decreased by the setup cancel function for the U. S. Select ON when you connect the projector to a device equipped with a SCART terminal that can output RGB signals. The SCART terminal is used mainly in Europe. This mode can be set only when the input signal is from the COMPUTER/COMPONENT VIDEO IN-1 terminal. Selects a desired language for the menu. Resets all menu settings except for IMAGE CAPTURE, PASSWORD FUNCTION, and LANGUAGE to the default. opt. FEATURE ASPECT PASSWORD FUNCTION MENU POSITION CINEMA MODE ?AUTO AUTO AUTO AUTO OFF English OK VIDEO SIGNAL WXGA SETUP SCART INPUT VIDEO SIGNAL 8 options OFF/AUTO/1280 x 768/ 1280 x 768RB/ 1360 x 768/ 1366 x 768 AUTO OFF Aè LANGUAGE RESET ALL WXGA SETUP 3. 75%/7. 5% SCART INPUT ON/OFF LANGUAGE RESET ALL 12 languages OK · · · You can select CINEMA MODE only when the input signal is a TV60, TV50, 480i, or 576i video signal. When SCART INPUT is set to ON, nothing is output to the external monitor. No computer signals are projected, either. SHUTTER does not work correctly during keystone adjustment. When you increase the value of OVER SCAN, noise may appear on the screen. You can set the IMAGE, SIGNAL, and SIGNAL-USER menus only when the signal is input. Important: 5. INFORMATION menu Menu option Feature description This menu shows a lamp operating time (hour) calculated assuming that LAMP MODE is LOW. · When the LAMP MODE is STANDARD, this menu shows a longer lamp operating time than the actual time. (See page 27 for the interval of lamp replacement. ) · When the lamp operating time is 0 to 10 hours, "0H" is displayed. When the lamp operating time exceeds 10 hours, the actual hours are displayed. · When the lamp operating time reaches 3000 hours, the bar turns yellow. When it reaches 3800 hours, the bar turns red. (The lamp lifetime is 4000 hours. ) Indicates the name of the terminal to which the currently projected video signal is being input. Indicates the resolution of the currently projected video signal. [. . . ] *2 The partial enlargement feature is not supported. *3 Supports a DVI-D terminal. Important: · · · · · Some computers aren't compatible with the projector. The projector's maximum resolution is 1280 x 800 pixels. It may not display images of higher resolutions than 1280 x 800 correctly. [. . . ]