User manual MITSUBISHI UD8350LU

[. . . ] DLPTM PROJECTOR MODEL UD8400U UD8400LU UD8350U UD8350LU User Manual UD8400 UD8350 This User Manual is important to you. Please read it before using your projector. U CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: CAUTION: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. NOTE: SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. [. . . ] TINT Use to adjust the tint of the projected image. Every time the button is pressed, the image appears more greenish. Every time the button is pressed, the image appears more reddish. To sharpen or soften the projected image (SHARPNESS): You can adjust the sharpness of the projected image using the menu. Select SHARPNESS by pressing the or button. Adjust the selected item by pressing the or button. Press the MENU button. To adjust the tone of white (COLOR TEMP. ): You can select a preset color temperature (white tone) using the menu. Select your desired color temperature by pressing the or button. To adjust the tone of white (To customize the color temperature): To customize (and store) the color temperature to your preference, carry out the following procedure. Press the or button to select the desired item. Press the or button to adjust the selected item. Repeat steps 4 and 5 for optimum adjustment results. BRIGHTNESS G BRIGHTNESS B 0 0 0 0 0 0 EN-42 Adjusting projected images (continued) To cancel the menu: 7. To enable the stored color temperature: 1. to USER in the IMAGE menu. About color temperature Color temperature is a way to show the differences in white. White of which temperature is low appears reddish. When the color temperature rises, white appears bluish. For example, you can change the color temperature using the following procedures. To raise the color temperature: Increase the CONTRAST B (blue) and decrease the CONTRAST R (red). To reduce the color temperature: Decrease the CONTRAST B (blue) and increase the CONTRAST R (red). · IfyousetallofCONTRASTR, G, andBtonegativevalues, theoriginalbrightnessoftheimagecan'tbe obtained even when you maximize CONTRAST in the IMAGE menu. Color Enhancer You can set the user-defined balance between the brightness and hue using the menu. (See page 32 for menu setting. ) With the IMAGE menu: 1. Select COLOR ENHANCER by pressing the or button. [. . . ] · If the resolution and frequency of your computer aren't shown on the table, find the compatible resolution and frequency by changing the resolution of your computer. · TV60 and TV50 are equivalent to 480i and 576i respectively. When these signals are supplied to the VIDEO IN or S-VIDEO IN terminal, the signal mode is indicated as TV60 or TV50. When they are supplied to the COMPUTER/COMPONENT VIDEO IN terminals, the signal mode is indicated as 480i or 576i. [. . . ]