User manual MITSUBISHI VS-50PH50

[. . . ] Warnings All warnings on the appliance and in the operating instructions should be adhered to. Instructions All operating instructions must be followed. Cleaning Unplug the power cord from the wall outlet before cleaning it. Attachments and equipment Never add any attachments and/or equipment without the approval of the manufacturer as such additions may result in the risk of fire, electric shock or other personal injury. [. . . ] Replacement parts When replacement parts are required, be sure that the service technician has used replacement parts specified by the manufacturer or parts having the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety check Upon completion of any service or repair to this product, ask the service technician to perform safety checks determining that the product is in a safe operating condition. 2. 3. 4. 5. 6. 7. 8. An appliance and cart combination should be moved with care. Quick stops, excessive force and uneven surfaces may cause the appliance and cart combination to overturn. Ventilation Slots and openings in the cabinet are provided for ventilation, ensuring reliable operation of the product and to protect it from overheating. Do not block these openings or allow them to be blocked by placing the product on a bed, sofa, rug, or bookcase. Ensure that there is adequate ventilation and that the manufacturer's instructions have been adhered to. EN-3 ENGLISH Important safeguards WARNING: Unplug immediately if there is something wrong with your product. Do not operate if smoke, strange noise or odor comes out of your product. In this case, unplug immediately and contact your dealer. · for VS-67PHF50U the temperature is lower than 10°C (50°F) or higher than 30°C (86°F) CAUTION: Battery replacement of the optional remote control R-XL50TX · Improper use may result in fire, injury, or spread dirt due to leakage, heat generation, or explosion. · Replace all the batteries with new ones. · Load the batteries with their (+) and (-) sides correctly. · Load the batteries from (-) sides first. Never remove the cabinet. This product contains high voltage circuitry. An inadvertent contact may result in an electric shock. Except as specifically explained in the Owner's Guide, do not attempt to service this product yourself. Please contact your dealer when you want to fix, adjust or inspect the product. NOTE: This symbol mark is for EU countries only. This symbol mark is according to the directive 2002/96/EC Article 10 Information for users and Annex IV. Do not modify this equipment. It can lead to fire or electric shock. Use the optional specified power supply cord. Place the product more than 5 cm (2 in. ) from the wall (except at the rear) to prevent blocking the intake, exhaust slots and ventilation of this product because hot air comes out of it. Carry the product by all four handles, not by two handles. Do not use the product under the following circumstances, which may cause fire or electric shock. · · · · · · in a dusty or humid place near a heater in a oily, smoky or damp place in direct sunlight with high temperature, such as the closed car where the temperature is lower than 10°C (50°F) or higher than 35°C (95°F) Your MITSUBISHI ELECTRIC product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste. Please, dispose of this equipment at your local community waste collection/recycling centre. In the European Union there are separate collection systems for used electrical and electronic product. [. . . ] The lamp power control circuit has failed. Contact your MITSUBISHI dealer. STAND BY STATUS The power circuit, cooling fan, or image processing circuit has failed. Contact your MITSUBISHI dealer. STAND BY STATUS STAND BY Light on for 1 second, off for 5 seconds STATUS STAND BY Displays number 1, 2, 3, 4 or 5. STATUS The image processing circuit has failed. Contact your MITSUBISHI dealer. STAND BY · VS-67PHF50U During image display, text is displayed on the screen. OVER TEMP · The ambient temperature may be too high, or the filter may be clogged. [. . . ]