User manual MITSUBISHI WS-55908

[. . . ] Projection Television Models WS-55908 and WS-65908 ® visit our website at w w w. m i t s u b is h i - t v. c o m RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user of the presence of uninsulated "dangerous voltage" within the product's enclosure that may be sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. [. . . ] name channels, and add channels to the 2 To change memory banks, press a SQV (Super Quick ViewTM) list. number button within 5 seconds of pressing the SQV button. 3 Press the SQV button repeatedly to cycle through the channels available in Channel (Figure 1) that bank. Select the channel you want to add or delete Adding SQV channels using the remote confrom memory, name, or add to the SQV trol: 1 Use the CHANNEL or number buttons Super Quick ViewTM list. to select the channel you want to add to the current SQV memory bank. Memory (Figure 1) 2 Press and hold the SQV button for about 3 seconds. When "SQV" and the After all available channels have been memmemory bank number appear under the orized with Memorize Channels, page 33, channel number, the channel has sucweaker channels viewed with Ant-A or Ant-B cessfully been added. can be added and unwanted channels can Removing SQV channels using the remote be deleted. control: Use the CHANNEL button on the remote 1 Press the SQV button repeatedly until control to view memorized channels. 2 While the channel number and SQV indiName (Figure 1) cator are still displayed on the screen, press the CANCEL button. If the Channels shown on Ant-A or Ant-B can be CANCEL button is not pressed before given names (up to four characters). After the SQV indicator disappears, the chanyou enter a name, it will appear on the TV nel will not be removed. 3 When the SQV indicator disappears, the channel has successfully been removed. (Figure 1) Antenna, Channel, Memory, Name, and SQVTM Antenna 35 Part III: Setup V-Chip Menu: V-Chip Lock V-Chip Lock (Figure 1) The V-Chip Lock allows you to Block or Allow programs based upon rating signals sent by the broadcasting station. The TV comes from the factory with the V-Chip lock in the Off setting. You can turn the lock On within the V-Chip Menu. The factory preset is TV-PG, allowing only programs rated TV-PG or lower. You can change the blocking level to various TV or movie ratings, lettered categories, and by time. After changing channels or inputs, there may be up to a 5 second delay before the V-Chip lock takes effect. The V-CHIP button on the remote control enables you to conveniently turn the lock on or off. Figure 1. V-Chip Lock menu V-Chip Lock Entry to the V-Chip Lock (Figures 2 & 3) The rst tim you sel e V C i pLock f ro e ct - h m the MAIN menu, or after you have canceled your passcode you will see the screen shown in g e 2. U e t h num er b to ur s e b ut ns on the remote control to input a four-digit passcode, then press ENTER. You can delete a character and move back one space by pressing CANCEL. [. . . ] To obtain warranty service, you must notify an authorized MITSUBISHI service center of any defect within the applicable warranty time period. Contact your nearest authorized MITSUBISHI service center whose name and address can be obtained from your MITSUBISHI dealer or by writing or calling MDEA at the address and telephone number provided below. Mitsubishi Projection TV Limited Warranty b. Warranty service will be provided in your home or, if required, at an authorized service shop, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. [. . . ]