User manual MITSUBISHI X490

[. . . ] LCD Projector User Manual X500 X490 S490 MODEL X500U / X490U / S490U EN ­ 1 ESPAÑOL ITALIANO DEUTSCH FRANÇAIS ENGLISH For X500U only CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN COMPLIANCE NOTICE OF FCC This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Department of Communications. [. . . ] appears on right side of image. 0 0 0 0 AUTO 0 0 0 0 User memory for signal setting This projector can memorize the maximum of 2 signal menu settings. Select MEMORIZE in the SIGNAL menu, and press the ENTER button. Press the $ or % button to select the memory which you wish to record (USER 1 or USER 2). · Any buttons are ineffective about 3 seconds of recording setting. Wait for recording to have been completed before operating the buttons. Initialite the setting which has been changed (Default) Select RESET in the SIGNAL menu, and press the ENTER button. Select the user setting Select MEMORY CALL in SIGNAL menu, and press the $ or % button to select the memory (USER 1 or USER 2). Select DELETE in the SIGNAL menu, and press the ENTER button. Press the $ or % button to select the memory which you wish to reset (USER 1 or USER 2). · Any buttons are ineffective about 3 seconds of resetting the recorded setting. Wait for resetting to have been completed before operating the buttons. EN ­ 17 ENGLISH ANAMORPHIC . . . . Select ON when playing DVD discs containing data of letterboxed images. Use to select the language used in the menus. ( / English / Español / Deutsch / Français / Italiano ) / RESET ALL . . . . . . . . . Use to reset the MENU settings (except LANGUAGE). Picture adjustment Adjusting the image You can adjust the picture by using the IMAGE menu. opt. 5. Press the $ or % button to adjust the color balance of the color. Repeat steps 4 and 5 for more adjustments. Exit the menu system by pressing the MENU button several times. · When using the setting which has been already prepared, select desired position VIDEO or COMPUTER in step 2. When the source is selected to VIDEO or S-VIDEO, VIDEO will be selected automatically. When the source is selected to COMPUTER, COMPUTER will be selected automatically. · When not using Color matrix adjustment, select OFF in step 2. XGA60 0 0 OFF COMPUTER STANDARD 0 0 0 IMAGE CONTRAST BRIGHTNESS sRGB COLOR MATRIX COLOR TEMP. [. . . ] Please refer to the table below for HEX code. ASCII HEX '0' 30h '1' 31h '2' 32h [Example] Set INPUT SELECT (of COMPUTER 1) to DIGITAL. (' 'is for ASCII code) Sending commands from the PC etc. 30 30 44 49 46 32 0D '0' '0' 'D' 'I' 'F' '2' ' ' 30 30 44 49 46 32 0D '0' '0' 'D' 'I' 'F' '2' ' ' Status code from projector Command for setting the INPUT SELECT to DIGITAL. [. . . ]