User manual MONITOR AUDIO VECTOR V1 2008

[. . . ] Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. This lightning flash with an arrow head symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to the persons. [. . . ] When set to the `Off' position it can be used with an amplifier that does not have a dedicated subwoofer or LFE output, such as a stereo 2-channel amplifier. if the amplifier or AV processor has a dedicated LFE or subwoofer output , the By Pass Filter Switch should be set to the `On' position. The low pass filter will then be set by the AV amplifier's internal filter. This is set in accordance with the amplifier or AV processor user guide. The table below can be used to set the frequency. this feature controls the upper frequency limit of the VW-8. The table below will help you to select the correct frequency at which to crossover depending on your main speakers. The LED indicates whether the unit is in stand-by mode or operational. It will be illuminated red when in stand-by, and green when operational. The logo badge on the front of the cabinet will also illuminate red and green depending on operational state. This control allows the subwoofer level or loudness to be adjusted in order that you can achieve a totally controlled, balanced sound. Once a desirable position is achieved it is important to check if the cables are long enough to reach comfortably without being under tension. Input connections can be made at this stage before the power is connected to the subwoofer. Never connect or disconnect any leads with the subwoofer switched on. Once the input cables are connected and the controls are set in accordance with the initial set-up procedure above, the subwoofer can be connected to the mains power supply and switched on at the mains power switch. Power Mode Switch in the `Auto' position, the unit should remain in standby with the power LED around the Logo Badge on the front and on the amp panel should be red, until the AV amp is turned on or a signal is received. To manually set up you sub, play a variety of music/ film excerpts that you are familiar with starting at a very low volume level, increasing to an average listening level once you are sure everything is working correctly. please now follow the instructions below: · For use with an AV amp/receiver (product with Subwoofer output) please select the by pass filter switch to the `On' position. If using the crossover frequency control please adjust in accordance with the table on page 5. ⷠThe Phase Control can now be set, please refer to pages 4 for further information. It is important to try a variety of music and film excerpts with which you are familiar in order to obtain the optimum overall settings. a lot of AV amplifiers/ receivers have an auto set up on them. [. . . ] The liability of Monitor Audio is limited to the cost of repair or replacement of the defective parts (at the discretion of Monitor Audio) and under no circumstances extends to consequential losses or damage. Declare in own responsibility, that the Vector VW-8 product described in this manual is in compliance with Technical Standards/Council Directives: (LVD) 73/23/EEC Low Voltage Directive EN60065: 09. Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current up and including 16 Ampere per phase and not subject to conditional connection. The equipment should be returned in its original packaging to the original supplier where possible, or to any other authorised Monitor Audio dealer. [. . . ]