User manual MOOSE Z-1100E

[. . . ] If you have any questions, contact your security representative right away. The system must be tested at least once per week to ensure proper operation. Contact your security representative for testing procedures and to schedule a regular maintenance program. If the system is malfunctioning, have service performed as soon as possible and only by qualified professionals. [. . . ] The blinking will cease 30 seconds after the system is armed. 9 Your system may utilize a conventional key switch for arming and disarming the system. Arming and disarming with a key switch is performed as follows: cl Arming 1. Insert your key into the key switch and turn. The red ARMED light will blink during the exit delay cycle and then light steady when the system arms. Insert your key into the key switch and turn. The red ARMED light will go out indicating that the system is disarmed. m U. L. Note: The control is not listed to Standard U. L. 294 Access Control Units If your system was purchased with the ACCESS feature, the control station can be used to switch other devices on and off or as a timed switch. This feature is most commonly used to activate an electric door release or switch lights on and off. Consult your security representative for more information. The " * " key may be used to: D Silence the control station sounder and the audible output during Auxiliary "A" (Fire) and Auxiliary "C" (Emergency) alarms. Cl Silence the control station sounder during Burglar alarms. NOTE: Pressing the * * *' key does not resef alarms or cancel reporting to the central statlon. Your system is capable of being serviced remotely from the alarm company's service office providing that the system is set up for Remote Programming. To program another code, return to step 2. 1. The control station will beep three times. The control station will beep two times. The READY and ARMED indicators will blink alternately and the other eight indicators will blink in sequence with each other when the programming mode is successfully entered (see note $). Press key 1, then key 0, then # which instructs the control that you wish to delete a code. The control station will beep three times to signify acceptance. Enter the number of the code (l-6) to be deleted. The system will automatically exit the programming mode. B An optional feature of your system allows you to assign a certain number of valid uses to User Code 6. After the code has been used the programmed amount of times, it automatically becomes disabled. This code may be assigned to a maintenance person, a maid, or anyone who you would like to be able to arm and disarm the system for a selected number of times without having to give out your regular code. [. . . ] Disarm: To turn the intrusion detection system off. Entrance Delay: Time permitted to enter the armed premises through a delay defined zone. Faulted: A detection area which is not secure such as a protected door or window which has been left open causing the control to loose its "Ready" status. . To force the system to arm when one or more zones are not ready. [. . . ]