User manual MOOSE Z900

[. . . ] Thank YOU for choosing the 2900 Security control. When properly installed and maintained, the system will provide years of reliable operation. It should be noted however, that no security system provides total protection over life or property. The following is a list of precautions that should be adhered to: 1. Please read this manual entirely and keep it in a secure place. [. . . ] See your security representative for more information. 10 Programming Certain features of your system are programmable through the control station. The programming mode is entered by pressing key 9 and holding for three seconds, then entering the Master User Code. Other programming functions may be possible that are not detailed in this section. Consult your security representative for a list of the user programmable features of your system. WARNING: Do not attempt to program the system unless you have been properly trained on programming procedures and you are sure that you fully understand thlsopwatlon. USER CODES Your system may be programmed to accept up to five regular User Codes and one Muster User Code. Each code may be comprised of any four digit sequence. (Do not program 1234 or 1111 as User Codes). Codes may be added, deleted, or changed as necessary. The Master User Code (code 1) performs all of the User Code functions plus allows access to the programming mode. User Code 6 may be programmed as a Temporary User Code with a limited number of valid uses, after which it becomes inoperable. This code may be assigned to a maintenance person, maid, or anyone who you would like to be able to arm and disarm the system for a selected number of times without having to reveal your regular code. A Determine your desired new User Code or Master User Code sequence. If you make an error while programming, press the " * " key five times and start over from step 1. WARNING: Pressing the " # " or l4 * " key while programmlng a code may result In Improper code operation, therefore you MUST return to step 1 when an error Is made. 0 To Change A User Code 1. The control station will beep three times. The control station will beep two times. The READY and ARMED indicators will blink alternately and the other eight indicators will blink repeatedly when the programming mode is successfully entered (see note + on page C). 4. Press a key (Z-6) which corresponds to the User Code you wish to program, or press key 1 to change the Master User Code, then press the " # " key. For example, press 1, then # to change the Master User Code, or 4 then # to program User Code 4, etc. The control station will beep three times to signify acceptance. 5. Enter the desired new 4 digit code sequence. After the fourth digit is entered, the control station will emit one short beep followed by one long beep then the system will exit the programming mode automatically. To program another code, return to step 2. 1. [. . . ] Hardwire Zones: The six areas of protection referred to as Zones 1 . Indicator Lights: The ten lights (LEDs) on the control station. Interior: The backup or second line of defense. Consists of one or more zones that detect intruders that have already entered the building. [. . . ]