User manual MORLEY PEDALS BCV-ST1

[. . . ] Most of all, we hope you enjoy using it as much as we enjoyed building it. THANK YOU! CONNECTIONS 9V: Use Morley's 9 VDC 300 milliamp regulated adapter only. Plug instrument into this jack using 1/4" guitar cable. OUT: Connect amplifier to this jack using a 1/4" guitar cable. [. . . ] NOTE: You'll find cords fit very tightly into our input and output jacks. The tight fit helps prevent the cord from becoming accidentally unplugged from the pedal. Make sure the cords are completely plugged in for best results. new battery plugged in. Make sure the polarity (+/-) is correct before inserting the new battery. When you replace the battery door, you will notice it fits very tightly against the battery. This prevents the battery from rattling inside the pedal. WARRANTY All Morley® pedals are warranted for two years from date of purchase. To obtain warranty service contact the store where purchased, or call 1-800-639-4668. OPERATION The Volume Mode has been specially designed for gradual volume increases as the pedal is moved from off (toe up) to mid-travel (halfway between toe up and toe down). From mid -travel to full on (toe down) the volume increases faster. Remove the battery door located on the bottom of the pedal (a short cord is attached to the door to help prevent loss). Once the door is off, the old battery can be removed from the battery snap and a NOTE: This pedal is not intended for use through an effects loop (send and return). FEATURES · WAH level Control: This knob controls the overall output level of the WAH effect. It does not change the wah sweep or range. WAH On/Off Switch: This switch turns the WAH effect "on" or "off". In the "off" mode the pedal functions as a volume pedal. Electro-Optical: The amount of light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique electro-optical design ensures smooth overall control of the WAH without unwanted noise typical with potentiometer (pot) controlled pedals. Silent Switching: To further enhance the noiseless operation of our switchless design, we've added FET silent switching. [. . . ] Our unique electro-optical design ensures smooth overall control of the WAH without unwanted noise typical with potentiometer (pot) controlled pedals. Silent Switching: To further enhance the noiseless operation of our switchless design, we've added FET silent switching. Offering smooth and quiet transition between Wah and Volume modes, absent of the pops and clicks associated with standard foot switches, this is ideally suited for studio recording and live performances. [. . . ]