User manual MORLEY PEDALS PDW

[. . . ] Most of all, we hope you enjoy using it as much as we enjoyed building it. THANK YOU! DISTORTION MODE: The Distortion is activated by pushing the Distortion switch (a red LED located above the switch will light when it's on). Three controls - Drive, Tone and Level - allow you to dial in the right sound. [. . . ] The pedal should be plugged in directly after your instrument and before devices that add gain (pre-amps, distortion and overdrive effects). Plugging into the pedal after these devices may cause unwanted volume in the "off" position. NOTE: How fast you move the pedal affects how the volume increases. The slower you move the pedal, the smoother the volume increase. WAH MODE: The Wah Mode is activated by pushing the Wah switch (a red LED, located above the WAH switch, will light when it's "on"). With this new series, we've maintained the full, thick sound and wide bandwidth of previous Morley WAH pedals and added more reactive sound. Now you can make your guitar talk and sing similar to the sounds of Hendrix, Clapton and other greats of the 60's and early 70's. CONNECTIONS 9V: Use Morley's 9 VDC 300 milliamp regulated adapter only. Plug instrument into this jack using 1/4" guitar cable. OUT: Connect amplifier to this jack using a 1/4" guitar cable. NOTE: You'll find cords fit very tightly into our input and output jacks. [. . . ] If an adapter is used, the LED will function (when in wah or distortion mode) until the adapter is disconnected. Here is a general recommendation for hooking up a WAH with other effects: · · WAH On/Off Switch: This switch turns the WAH effect "on" or "off". NOTE: This pedal is not intended for use through an effects loop (send and return). Try the following settings to get started. . . . . . . . . . . · DISTORTION On/Off Switch: Turns the distortion effect "on" or "off". · Electro-Optical: The amount of light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique electro-optical design ensures smooth overall control of the WAH without unwanted noise typical with potentiometer (pot) controlled pedals. Pro Series Distortion WAH/Volume MODEL PDW · DRIVE control: Adjusts the amount of distortion. [. . . ]