User manual MORLEY PEDALS PWVSS

[. . . ] You now own the best Wah Volume pedal made! Please take a few minutes to familiarize yourself with the features of your new pedal. With common sense handling, it should last for years. [. . . ] The pedal should be plugged into your signal chain directly after your instrument and before devices that add gain (such as preamps, distortion and overdrive effects). Plugging into the pedal after these type of effects may result in unwanted volume in the "off" position. NOTE: How fast you move the pedal affects how the volume increases. The slower you move the pedal, the smoother the volume increases. The Wah Mode is activated by pushing the Wah switch (a red LED, located above the WAH switch, will light when it's "on"). With this new Pro Series pedal, we've maintained the full, thick sound and wide bandwidth of previous Morley WAH pedals. Now whether you want to emulate the classic sounds of Hendrix or Clapton, recreate the lush tones of Vai or Satch or simply create your own vibe, it is within your reach. SPECIFICATIONS AC ADAPTER Use Morley's 9VDC 300 milliamp regulated adapter only. Using a non-regulated adapter could cause a low frequency hum in your amplifier. Using the wrong polarity may damage the pedal. POWER: 9 Volt Battery or 9VDC 300 milliamp regulated adapter (center pin is negative) CURRENT DRAW: 12 mA @ 9 VDC WEIGHT: 3. 0 lb. / 1. 36 kg INDICATOR: Wah mode LED on Volume mode LED off INPUT IMPEDANCE: Greater than 100K ohms OUTPUT: Will accept loads more than 10K ohms BATTERY The PWV-SS is designed to use one 9 volt battery when not using an adapter. We suggest you use a good quality alkaline battery. To prolong battery life, unplug your cord completely from the input jack when not using the pedal. [. . . ] When the LED is off, the pedal is in volume mode. 185 Detroit Street, Cary, IL 60013 Phone: (847) 639-4646 Fax: (847) 639-4723 www. morleypedals. com · · · Pro Series WAH VOLUME with Silent Switching · Model PWV-SS OWNER'S MANUAL [. . . ]