User manual MORPHY RICHARDS BRITA WATER FILTER KETTLE 43539

[. . . ] Please read and keep these instructions Do not place the kettle where the mains lead could fall into a sink. If the supply cord is damaged, it must be replaced by the manufacturer, it's service agent or similarly qualified person in order to avoid a hazard. Getting the best from your new water filter kettle. Safety first Always pour water slowly and carefully to prevent the splashing of scalding water. [. . . ] The appliance inlet must be dried before the appliance is used again. The kettle is only to be used with the stand provided. Caution: to prevent damage to the appliance, do not use alkaline cleaning agents when cleaning, use a cloth and mild detergent. When cleaning the kettle with cleaning agents, you must take out the BRITA filter cartridge and the funnel. After cleaning and thoroughly rinsing the kettle, the BRITA filter unit can be re-inserted. Before using the appliance for the first time, fill with water, boil, and pour away. Filtering your water improves the taste and appearance of beverages by reducing limescale, lead, chlorine and other impurities. This is how the BRITA MAXTRA filter cartridge works: The unique BRITA MAXTRA filter cartridge A offers improved filtration due to MAXTRA technology. The natural MicroporeFilter in combination with the powerful ProtectFilter reduces chlorine and limescale for a great natural taste and permanently absorbs metals such as lead, copper and aluminium for your wellbeing. Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. UK only If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. WARNING: The plug removed from the mains lead, if severed, must be destroyed as a plug with bared flexible cord is hazardous if engaged into a live socket outlet. Little effort - great effect: Preparation of your BRITA MAXTRA Cartridge is very simple. Please follow the steps below to enjoy BRITA filtered water. Preparing the cartridge B: To prepare your BRITA MAXTRA cartridge, please remove the protective wrapper (note: the cartridge and inside wrapper may appear moist, this is simply condensation). Immerse the cartridge in cold water and shake it gently to remove any air bubbles, the filter is now ready for use. Note: As is required for some other water filter cartridges, there is no need to pre-soak the MAXTRA cartridge. 2 Insert in the funnel C: Place the filter cartridge into the funnel and push downwards until it fits firmly in the funnel. Should stay in place if the funnel is turned upside down. 3 Rinse the cartridge D: Fill the funnel with cold tap water and allow it to filter through. Discard the first two fillings or use the water for your plants. These first two fillings are used to flush the filter cartridge. [. . . ] Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. Repairs have been attempted by persons other than our service staff (or authorised dealer). Where the appliance has been used for hire purposes or non domestic use. [. . . ]