User manual MORPHY RICHARDS COMFIGRIP

[. . . ] Please read and keep these instructions Getting the best from your new iron. Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. Jet cleaning (certain models only) Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing. [. . . ] Shot of steam Press the shot of steam button ¤ to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range shown on the control dial. Note: For optimum steam quality, do not operate the shot more than three times in succession. , , , Â Spray button Shot of steam button Variable steam button Filling hole with cap Spray nozzle Soleplate Temperature control dial with indicator Water tank (Illuminated on certain models) Life long anti-scale (certain models only) Temperature indicator light (red) Graduated filling beaker Self clean button (certain models only) Note: The steam facility should only be used on garments which are suitable for ironing at the 2 and 3 dot settings. When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section). Textiles and clothes are supposed to carry ironing instructions. If they don't you should follow the temperature guide on the previous page, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light , , which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Soleplate (certain models only) Ê Turbo Tip Powerful shot of steam gets into the trickiest of places Á Constant Steam Remove all creases at a level you control Ë Press and Set Removes moisture to set a crease-free finish Vertical steam Hold the iron in a vertical position between 1cm and 2cm away from the item D. Press the shot of steam button ¤, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. Note; For optimum steam quality, do not operate the shot more than three times in succession. No drip system Your iron is fitted with a no drip system which is designed to prevent water escaping from the soleplate when the iron is too cold. During use, the no drip system may emit a loud click, particularly during heat-up or whilst cooling down. This is perfectly normal and indicates that the system is functioning correctly. Auto shut-off (certain models only) If your iron is fitted with the auto shutoff function it will automatically shut down after a set period. [. . . ] Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. [. . . ]