User manual MORPHY RICHARDS CYCLONIC BAGLESS VACUUM CLEANER REV 4

[. . . ] Never pick up acids, asbestos or asbestos dust. Never touch the plug or cable with wet hands. Unprofessional repairs can be dangerous for users. Use only Morphy Richards spare parts and accessories. [. . . ] · 5 Using attachments Follow steps 1-4 but set the carpet height adjustment knob to the TOOLS setting. Remove the hose connector Í from the rear of the cleaner. Lift the hose · from the top handle hook. Insert the hose clip into the hose clip slot Ë. Push the required attachment firmly onto the end of the hose. 4 UK Helpline 0870 060 26 Replacement Parts 0870 167 6635 Ireland Helpline 1800 409119 73360 rev4 11/7/06 14:43 Page 5 · If additional length is required, attach one or both extension tubes. IMPORTANT: Always fix the hose clip ~ to the main body slot Ë when using the hose and tools. Never over extend the hose such that the cleaner is pulled over. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. 6 7 Empty out the dust canister Ó. Re-fit the central mesh filter. D 6 · 8 Shake the pleated filter to remove all dust. 9 Re-fit pleated filter with lid into the dust canister by lining up the two arrows and turning the lid 1/4 turn clockwise to lock. · 10 Re-fit dust canister into cleaner and push to lock into position. Then re-fit front cover. Using & cleaning turbo nozzle (Certain models only) Attach the turbo nozzle to the hose end connector Í for use on upholstery and stairs. After use your turbo nozzle may become clogged. Turn over the nozzle and pull away any hairs or fibres. If they are tightly wound around the brush carefully snip the fibres with scissors, being careful not to damage the brush bar, pull away from the brush bar and dispose. E EMPTYING Empty the dust canister regularly even if it does not look full this will maintain the performance. 1 2 Remove the front cover by lifting the cover release lever ¤ E. Lift-up the dust canister release Î and pull the canister away from the main body. Turn the lid 1/4 turn anticlockwise to unlock, lift off the lid with pleated filter, Ì put to one side. F Lift out the central mesh filter Ô from the dust canister Ó G. Brush clean if necessary. F 3 4 5 www. morphyrichards. com 5 73360 rev4 11/7/06 14:43 Page 6 G SAFETY CUT-OUT If the cleaner overheats a motor protection thermostat will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for at least 60 minutes. Check the airways for blockages, empty dust canister and clean the filters before restarting. Exhaust filter I The exhaust filter is located below the dust canister compartment. Remove the exhaust filter Ú by pulling forward at the top and lift it away. [. . . ] This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. 5 6 · EXCLUSIONS The fault has been caused or is attributable to accidental use, mis-use, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. Repairs have been attempted by persons other than our service staff (or authorised dealer). This guarantee is valid in the UK and Ireland only. 2 3 For electrical products sold within the European Community. [. . . ]