User manual MORPHY RICHARDS ESSENTIALS PRECISE STEAM CLEANER REV 1

[. . . ] 70536 rev1 version2 7/9/07 14:42 Page 1 Essentials Precise Steam Cleaner Please read and keep these instructions Quick start 1 Fill the tank up to a maximum of 1. 0 litre of water (using warm water will reduce the heat-up time). Screw cap on and tighten fully. 2 Attach the hose and required accessories. 4 Press the on/off button to start heat-up. When orange light turns off, the steam is ready. 5 Press the trigger on the handle to release the steam. [. . . ] Direct the steam at a cloth or into a bucket or sink until the steam is emitted evenly. Warning: At the start, hot water may be ejected. 3 Keep the steam trigger pressed and direct the steam at the surface to be cleaned, removing the dirt by moving the steam jet backwards and forwards over the area. To stop the steam jet, release the steam trigger. IMPORTANT: Do not hold the steam jet concentrated in one place for too long. · · 2 Some tasks may be easier with only one tube fitted or none at all. To connect the desired accessory directly to the hose handle, slide the handle into the accessory head or tube until it locks in place J. 2 H Floor nozzle Ì The floor nozzle is used for the cleaning of large, washable walls and floor areas. The floor nozzle can be used with or without the cotton towel Ó. · 1 2 3 Sensitive surfaces, wood, linoleum etc. Fit the elbow attachment Ï to the floor nozzle and twist 1/2 a turn K. Fit the floor nozzle to the extension tube or handle L. To fit the cloth to the floor nozzle pull the cloth under the clips on both sides. Extra cloths can be ordered through our helpline. Alternatively any strong, uncoloured cotton cloths may be used M. The cleaning power of the cloth can be optimised by turning and changing the cleaning cloth regularly. To clean very dirty areas, move the cleaning nozzle over the surface more slowly in order to increase the cleaning action of the steam. IMPORTANT: The cleaner is not suitable for cleaning unsealed wooden floors, laminates, soft plastics or wooden furniture. If in doubt check with the flooring manufacturer. I J4 K To control the steam temperature and the cleaning power move the handle closer to or further away from the surface being cleaned. · Steam adjustment The steam adjustment control , varies the steam output. Turn the knob fully anti-clockwise for the maximum amount of steam or clockwise for decreasing amounts of steam H. · L ACCESSORIES M Warning: Unplug the steamer and allow to cool before fitting or changing attachments as they become hot during use. Attach the desired accessory to the hose handle . Extension tubes can be attached to the handle for extra reach. Accessory adaptor 1 Push the jet nozzle adaptor Û as far as it will go onto the connection nozzle until you hear it click into place N. [. . . ] Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. All Morphy Richards products are individually tested before leaving the factory. [. . . ]