User manual MORPHY RICHARDS GOBLIN 1400W WET AND DRY CLEANER

[. . . ] If the electrical cable becomes damaged the complete cable assembly must be replaced. Do not attempt this task yourself, contact Goblin using the helpline number. Electrical requirements When using this appliance outdoors it should be additionally protected by a RCCB (Residual Current Circuit Breaker). Please check that the supply voltage details given on the rating plate (located on the side of the motor housing inside the tank) are in accordance with your electricity supply. If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. [. . . ] Clean it under gently running water, allowing it to dry naturally before refitting. If frequent wet usage is expected we recommend that you use the foam filter which is specifically designed for wet usage. Remove the cartridge filter and slide the foam tube over the float basket then secure with the holder turning the holder a 1/4 turn to lock it into place DÈ. Cartridge filter Your cleaner features a removable heavy duty cartridge filter. Designed to withstand the impact of large debris and liquids, proper maintenance will give it a much extended life. The filter has a locking key to hold the cartridge filter in place simply position the filter and turn the locking key clockwise or anti-clockwise to fit or remove DË. Float shut-off When the waste tank is full of liquid the float shut-off valve E, automatically cuts off the suction which is indicated by a higher pitched noise from the motor. 2 Switch off and disconnect electrical supply by removing the plug from the wallsocket. 3 Raise hose to drain liquid back into the tank. 4 To minimise any back-flow of liquid keep hose in raised position until emptied. IMPORTANT: Do not attempt to remove the float as this is important to safe use. If the cleaner overturns during use turn the motor off, return to upright and wait until the float falls free. The valve will operate whether the filter is fitted or not. Dry usage The cartridge filter must always be fitted when not picking up liquids. Failure to do so may cause damage by allowing dust and larger particles into the motor (and invalidation of the guarantee). To clean the filter, remove it and brush the grooves with a soft brush, ensuring you don't damage the surface. If you need to pick up very fine dust (eg cement, plaster, ash), we recommend you use a paper bag. Always remove the inner tank when using a paper bag. Í D È Í E Ë È Exhaust filter In addition to the cartridge filter your cleaner also has a filter fitted to the exhaust. This is housed at the rear of the motor housing. To access the filter remove the holder by inserting your fingers into the bottom of it and pulling B. The filter can then be removed and cleaned by either gently tapping or rinsing in water. Once dry, fit the filter into the holder. Replace the holder by first locating the bottom into position B, and then pushing the top firmly until it clicks into position. Ensure that the exhaust filter flap has been fitted securely otherwise it may come off during use. Blower Your cleaner may also be used to blow debris instead of vacuuming. To use the blower facility remove the exhaust filter holder as described under `Exhaust filter'. [. . . ] 5 The guarantee excludes consumables such as bags and filters. 6 Goblin are not liable to carry out any type of servicing work, under the guarantee. All Goblin products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should take the appliance to your nearest service agent. [. . . ]