User manual MORPHY RICHARDS IB26005

[. . . ] IMPORTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED, MUST BE DESTROYED AS A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET. Two year guarantee It is in your interest to retain the retailers receipt as proof of purchase. Please quote the model number if the product develops a fault. This number can be found on the handle of the product. All Morphy Richards products are individually tested before leaving the factory. [. . . ] The Company, therefore, reserves the right to change the specification of its models at any time. 446/8001/23 Rev 1 Imported by : Morphy Richards Ltd, Talbot Road, Mexborough, S64 8AJ Instructions & style guide Thank you for buying your new Morphy Richards Clipper set. Please read these instructions carefully before use and keep in a safe place for future reference. Cutting guide Never use the product to cut wet hair. It is designed to work on dry hair only. Key features Tips Make sure that the clipper is clean, properly oiled and in perfect working condition. Place a towel around the neck of the person, to prevent hair from falling down inside the collar. Position the person whose hair is to be cut on a chair so that his/her head is at your eye level. Comb the hair to remove all tangles. the hair as your guide, slowly move the clipper over, around and behind the ears. For the back of the neck and side burns, hold the clipper upside down and holding it against the skin at the desired length, move downwards. Short cuts to perfect crew cuts Always cut from the back of the neck to the crown, using the longest attachment comb. Holding it flat against the head, slowly move the clipper up through the hair. Using the same technique for the sides, cutting from the bottom to the upper side of the head. B oil brush scissors E Cutting hair with attachments (for medium to long cut) To attach combs, hold comb with teeth up, snap comb attachment firmly to the bottom of the clipper blade. power screw Attachment Attachment Attachment Attachment comb comb comb comb 1 2 3 4 Leaves Leaves Leaves Leaves hair hair hair hair approx. 3mm in length 6mm in length 9mm in length 12mm in length Maintenance Your clippers were examined to ensure that the blades were oiled and aligned before leaving our factory. Blades must be realigned if they have been removed for cleaning or replacement. To realign the blades, simply match the upper and bottom blades teeth up, point for point. (End of top blade teeth should be approx. If blade alignment is incorrect, add a few drops of oil to the blades, turn the clipper on for a few moments, turn off and unplug. To maintain the clipper in peak condition, the blades should be oiled every few haircuts. Simply place a few drops of oil on the teeth of the blades. Due to the high speed of the clipper the correct oil must be used. Do not use hair oil, grease, oil mixed with kerosene or any other solvent. Solvent will evaporate and leave the thick oil, which may slow down the blades. [. . . ] The lever adds versatility to your clipper by allowing you to gradually change the closeness of your cut without an attachment comb. When the lever is in the uppermost position, the blades will give you the closest cut and leave the hair very short. Pushing the lever downwards gradually increases the cutting length. Outlining Outlining does not require any attachments. Take the clipper and push the lever up to the close cut-position. [. . . ]