User manual MORPHY RICHARDS IB27004

[. . . ] 3 AC MAINS ADAPTOR (SUPPLIED) You can connect the set to the mains using a mains adaptor. Only use a mains adaptor which supplies DC 6 V with the negative pole at the centre pin of the plug ( ). · Check that the mains voltage indicated on the rating plate of the adaptor matches your local mains voltage. · If the mains adaptor is equipped with a voltage selector, set this to the local voltage. [. . . ] If the FM signal received is too strong (in direct vicinity of the transmitter) you can retract the aerial. For MW and LW reception, the set has a built in aerial, so the telescopic aerial is not needed. You can direct the aerial by turning the radio. For short wave reception (SW) extend the telescopic aerial and position it vertically. · · Selecting distant or local · Slide the DISTANCE/LOCAL selector to the LOCAL position to reduce interference and distortion when listening to strong FM or SW stations. This causes the signal to be weakened, thus reducing interference. The switch should normally be left in the DISTANCE position. Automatic tuning · To activate automatic station search (auto tuning), press + or - until the frequency display begins to run, then release the button. -The search stops as soon as a station is located. -Stations which are received with a weak field strength may be skipped. These can be tuned manually by pressing the + or button. 6 Manual tuning · · Briefly press the + or - button to tune in the corresponding direction in individual steps. If you keep the button depressed, you can rapidly scan large frequency ranges. -When the button is released, auto tuning is automatically selected. If you briefly press one of the + or - buttons, manual tuning is selected. · Last station memory · Your unit is provided with the function LAST STATION MEMORY. The station playing when the radio was switched off will automatically be selected. Storing stations You can programme 20 stations into the memory, 5 on each waveband. · Select the waveband with the BAND SELECTOR switch. · Tune to the station you want to store. -The indication M starts flashing on the display for 5 seconds. · Press the preset number button (1. . . . 5) to assign the station. · Press MEMORY button again to store the station. · Select and store all desired stations in each memory location. Note: If a station is not stored within 5 seconds M is flashing, the storing mode is abandoned with no change to the current memory. Calling up a stored station · · Select the waveband with the BAND SELECTOR switch. [. . . ] Adjust the aerial for best reception: FM incline and rotate telescopic aerial. SW: extend telescopic aerial vertically. Keep the set away from electrical equipment. Switch off the set, disconnect the mains adaptor / remove batteries, reconnect after a few minutes. [. . . ]