User manual MORPHY RICHARDS IB28034

[. . . ] 2 Insert a battery size 9 volts PP3/6LR61 (Ensure battery is inserted correctly). 3 Replace the battery compartment cover. Should a power interruption occur the clock will continue to run, however, time keeping will not be accurate. The time will be displayed but the backlight will be extinguished to conserve battery life. [. . . ] Press the UP or DOWN to set the alarm time. Repeatedly press the SNOOZE button to the set the alarm to sound every day. (SUN MON TUE WED THU FRI SAT appears) or Monday through to Friday (MON TUE WED THU FRI appears) or only Sunday and Saturday (SUN and SAT) appears. Press the DISPLAY button once to the set the alarm mode: buzzer (bell), press (radio) and press again to turn the alarm completely off. again to set to Press MODE button to store the ALARM 1 time. Then the ALARM 2 time starts flashing, repeat steps 1-4 to set the ALARM 2 time. If no button is pressed for 15 seconds, the alarm time is stored automatically and returns to the original display. 4 5 Cancelling the alarm 1 To temporarily silence the alarm ( or ), press the SNOOZE button. This silences the alarm for about 9 minutes. The alarm will sound again at the next preset alarm time. To cancel the alarm permanently, press the MODE button 3 times, then press the DISPLAY button until the icons disappear. Repeat for alarm 2 if necessary. 2 6 Radio operation · · 1 2 3 4 To obtain maximum FM reception fully extend the wire FM aerial (which is located at the rear of the unit) and alter the direction of the wire for best results. The aerial for the MW waveband is located inside the unit. To obtain maximum MW reception rotate the clock radio. Press the POWER / SLEEP button. Adjust the VOLUME control to a suitable level. Press the BAND button to either MW or FM as desired. Press UP or DOWN buttons to select the desired station. The radio automatically tunes to the next higher or lower station with a strong signal. 5 To switch off the radio, press the POWER / SLEEP button. Notes If no strong signal is found, press the UP or DOWN buttons to stop tuning. Using the memory You can store up to 20 stations in memory (MW x 10, FM x 10). Follow these steps to store a station into memory. 1 2 3 4 Tune to the band and station you want to store. Within 15 seconds, press buttons 1-5 on the display for the desired memory location. [. . . ] The product should be kept in a warm environment free from dust and damp. For external cleaning use only a soft, clean, damp cloth. Use of detergents may damage the finish. Technical specification AC Power supply Battery back-up Radio : : : : 230V 50Hz 9V DC type 6LR61/PP3 (not included) FM 87. 5MHz - 108MHz MW 522Khz - 1620kHz VENTILATION WARNING The normal ventilation of the product shall not be impeded for intended use. HAZARD WARNING To prevent fire or shock hazard do not expose this apparatus to dripping or splashing. 11 Guarantee Morphy Richards products are manufactured to internationally accepted quality standards. [. . . ]