User manual MORPHY RICHARDS IB29007

[. . . ] 3 Replace the battery compartment cover. Should a power interruption occur the clock will continue to run, however, time keeping will not be accurate. The time will be displayed but the backlight will be extinguished to conserve battery life. The memory will retain details of the clock time and alarm settings. If the optional battery is not installed in case of the AC power failure the clock will flash at 12:00 when power is restored. [. . . ] Press PLAY/PAUSE to listen to the wake up volume level. Rotate the volume to the desired wake-up volume level. Press the OFF button to turn off the unit. If the cd compartment is empty, the alarm tone will default to the buzzer. 6 Adjusting snooze duration The snooze control temporarily silences the alarm and allows extra sleep time after the alarm has sounded. You can use the SNOOZE feature repeatedly for up to 2 hours, after which time the unit will turn off. 2 Press the UP or DOWN button to set the snooze period (default is 9 minutes). Snooze can be set from 1 minute to 30 minutes. The alarm will repeat after the set period. Stopping the alarm 1 To silence the alarm temporarily: · Press the SNOOZE button and the alarm will sound again when the snooze period is over (see `Adjusting snooze duration' above). To stop alarm from sounding: · Press the OFF button and the alarm will sound again the following day at the set time. To cancel the alarm completely: Press the CANCEL button, then press the WAKE 1 or 2 buttons and the selected alarm will be cancelled. The wake / alarm indicators will also be cancelled. · If you press WAKE 1 or 2 button again, the previous set alarm time/s will be used. Note: If the alarm is uninterrupted it will stop sounding after 2 hours. 2 3 7 Listening to radio 1 2 3 4 Press the RADIO ON / BAND button to switch on the radio. Press the RADIO ON / BAND button to select FM, MW. Press the UP or DOWN buttons to manually set to your desired station. Adjust the VOLUME control to your desired listening level. FM wire aerial To obtain the maximum FM reception fully extend the wire FM aerial (which is located at the rear of the unit) and alter the direction of the wire for best results. The aerial for the MW waveband is located inside the unit. To obtain the maximum MW reception rotate the cd clock radio. Automatic station search 1 2 Press and hold the UP button until `UP' is displayed on the display panel and it will automatically search up the radio frequency. Press and hold the DOWN button until `DN' is displayed and it will automatically search down the frequency. Radio presets 1 2 3 4 Refer to `listening to the radio' to tune to the desired radio station. To store the frequency into the memory, press PRESET / SET button, the preset station number will be automatically assigned the next available number and will appear on the display. Press the PRESET / RECALL to select another preset location. Press PRESET / SET to confirm your settings. Radio frequency tips · There is a maximum of 11 (10 preset locations and 1 alarm memory location) preset stations that can be stored. [. . . ] For external cleaning use only a soft, clean, damp cloth. Use of detergents may damage the finish. Technical specification AC Power supply Battery back-up CD player Laser Radio Earphone jack socket : : : : : : : 230V 50Hz 9V DC type 6LR61/PP3 (not included) Frequency response (60dB) 30Hz to 20kHz = 780nm Max power = 2mW FM 87. 5MHz - 108MHz MW 531KHz - 1611KHz 3. 5mm diameter WARNING : This unit uses a laser beam. To prevent an accident occuring the unit should only be opened by a qualified engineer. If the door interlocks become defective the laser may cause invisible radiation. [. . . ]